Vertical blue lines

Collapse
X
Collapse
 
  • Page of 1
  • Time
  • Show
Clear All
new posts
Previous template Next
  • billy66
    Senior Member
    • Mar 2010
    • 124
    #1

    Vertical blue lines

    I have a NEC 1960NX monitor. It works great, only issue is about a 2" vertical blue lines from top to bottom. I've narrowed the issue down to the ribbon type connector that goes from the actual screen to the board. If I push down on the tape in various places, the lines go away. I can't see any way of fixing this... Am I out of luck? Toss the screen and keep the good boards for parts?

    The pic shows the board I'm talking about... as I can't think of what to call it. And the close up is the ribbon cable I push on.
    Attached Files
    Tags: None
    • billy66
      Senior Member
      • Mar 2010
      • 124
      #2
      Re: Vertical blue lines

      Oh, and I don't have to push on the ribbon right where you see it in the photo. I can push on the side, I even varied my pushing. Sometimes the pushing doesn't work at all. I'm not sure if it is a "push and it makes connection issue" or that my finger makes a ground point?

        Comment

        Previous template Next

        Related Topics

        Collapse
        • Stanley1843
          Screen Display Vertical Multicolor Lines
          by Stanley1843
          Hello, I have a screen in where sometimes when I open it pop-up vertical multicolor lines (I would say the most of them are green). If I tun off and turn on the screen the lines dissapear or if I leave open the screen after approximately five minutes the lines gone. I measured the below voltages on the main PCB and on the T-CON board and the voltages are the same when it doesn’t display the vertical lines and when it displays the vertical lines. Also, I cleaned all the connectors very good with IPA. I moved back and forth the connectors and the COF tabs but the vertical lines didn't displayed...
          06-29-2024, 11:54 AM
        • visionbluedemon
          Help. Sony kd-65x85dj vertical lines
          by visionbluedemon
          First. it has no picture at all. i solved it by covering the ckv lines using tape to to block the connections

          Second. now has picture but with vertical lines that follow the image. tcon board ic overheating

          tried blocking LC lines too, but same results



          is it lcd panel issue or tcon board issue?...
          07-25-2025, 04:56 AM
        • gpo23
          Sony KDL-40V3000 - Vertical lines
          by gpo23
          Hello,

          i order a t-con because i had bad colors on my SONY KDL-40V3000 :




          With the new t-con the color are good but there are vertical lines on all the screen :




          I've tried the old t-con and it returned to the initial issue (bad colors but no vertical lines)

          Is there a way to fix the vertical lines on the new t-con ?

          Thank you for your help

          gpo23...
          10-04-2023, 09:11 AM
        • blake.s
          LG 65UJ6300-UA has blue haze and small white vertical lines
          by blake.s
          I have a LG 65 inch tv. When i turn it on it has a blue haze and slightly noticeable white vertical lines. I am wondering if this is the t-con or the panel tabs?

          ...
          08-04-2021, 01:39 PM
        • viking509
          vizio e65 e3 LED tv color vertical lines center tv only
          by viking509
          I recently replaced the led backlights with LB65041 LED Backlight Strips and after putting it back together the backlights work but there are only colored vertical lines only in the center of the tv. I can see the Netflix logo (jumbled) after a minute or less the screen went dark. When I turned it on again the lines were back. Then I replaced the t-con board but the same vertical lines in the picture. My question is what is my next step? Could it be a source tab bond issue? A buffer board issue? Could I have loosened a connection to the panel when replacing the backlights? Should I replace the...
          03-21-2023, 12:48 AM
        • Loading...
        • No more items.
        Working...