Stop and start non stop loop when firing up s laptop, two vcap have slight scratcheswwwwwwwwwwwwwwwwwwwwwwwwwwwwwwwwwwwwwwwwwwwwwwwwwwwwwwwwwwwwwwwwwwwwwwwwwwwwwwwwwwwwwwwwwwwwwwwwwwwwwwwwwwwwwwwwwssssssssssssssssssssssssssssssssssssssssssssssssssssssssssssss
restart loop
Collapse
X
Related Topics
Collapse
-
Before proceeding with a component level repair, the usual troubleshooting process was followed:
1. Disassemble and unplug everything except the power connector.
2. Replace RAM.
3. Replace CPU.
4. Rewrite BIOS.
Unfortunately the board was still stuck with a 0.75A power consumption at 19V.
After reflowing both GPU and north bridge in one shot (it can't hurt) there was an instant improvement with a constant 1.75A power consumption, but I immediately noticed smoke and the typical smell coming from the GPU area.
I thought to myself "Well,... -
by TakeatrySamsung QLED QN50Q — purchased 2022 started experiencing a delay in the picture coming on in the morning less than 2 years later. Did not know the term boot loop at that time. As the loop delay ran into a few minutes did all the recommended troubleshooting, soft and hard reset, changing cables and outlet locations, no help. As the delay increased contacted Samsung tech group and allow them remote access the tv. Tech was moving too fast to see exactly what he was doing but this ultimately it was also no help. Lived with the delay until it stretched out over 6 hours. Pulled of off the back cover...2 Photos
-
by AskicHello,
I have HP 450 G4 laptop with DA0X83MB6H0 motherboard that is stuck at boot loop restart.
When powering ON, firste there is a dealy about 10 sec before showing HP logo and then after 15 to 20 sec it restarts itself.
If I try to enter BIOS (with F10) or Sys diagnostic (F2) there is a message "Entering Setup" or "Entering diagnostic" and after 20 sec restart.
I have tried with different BIOS dumps, exchange RAM modules remove/short CMOS battery and many more, but it didn't change behavior.
Keyboard is working since it detects... -
by x_orange90_xI don't know if anyone here has experience with Japanese slot (pachislo) machines, but I sure hope so. I bought this machine last week in semi-working order. It would play and the reels would spin, but the stop buttons would not stop them at all. I found that the high-frequency filtering tantalum capacitor was bad on the reel stop board, along with the fuse being blown. I replaced the fuse and removed the capacitor. I haven't replaced the cap yet because I didn't have one on hand, but it's not necessary for the operation of the machine.
The issue now is the Stop buttons are intermittently... -
by A1yn88Hello everyone.
An HP Pavilion - 15-bc414nq laptop that restarts every second came into service. I took it apart and found 3 burnt capacitors on the 19v line. I took them down. Now the laptop starts and restarts once after 20 seconds, after the restart it stays for 20 seconds and then stops.
I noticed that I have 0V on Bios pin 5 / 6 (PCH_SPI1_SI_R / PCH_SPI1_CLK_R) and I don't know if it's normal or if I should have something.
There is another coil near the processor that is 0V, but it is not the exact diagram for this laptop and I don't know what exactly should be there.... - Loading...
- No more items.
Comment