Solar panel - circuit for recharge battery during the night

Collapse
X
 
  • Time
  • Show
Clear All
new posts
  • nings
    Member
    • Apr 2010
    • 13

    #1

    Solar panel - circuit for recharge battery during the night

    Hello,

    I have a problem with my solar panel during winter.
    The sun is hidden during almost all the day and it's not enough for recharge completely my batteries about 2 months per year. I recharge manually the batteries during evening but it's not very practical.

    I search a way for recharge the batteries with a power supply only during the night (no power coming from solar panel) for not have two power sources in the same time and only when the battery level is low. The must is a relay who can cut the power going to the power supply when it's not necessary.

    Someone know if something like that already exist ?
    It's a little dangerous to play with that and my knowledge is limited.

    Thank you
  • keeney123
    Lauren
    • Sep 2014
    • 2536
    • United States

    #2
    Re: Solar panel - circuit for recharge battery during the night

    So a quick search on the internet brought up this site.

    https://www.batterystuff.com/solar-c...ge-controllers

    Comment

    • nings
      Member
      • Apr 2010
      • 13

      #3
      Re: Solar panel - circuit for recharge battery during the night

      Hello,

      I have already a controller for charge the batteries but these devices doesn't support external power.

      But thank you

      Comment

      • keeney123
        Lauren
        • Sep 2014
        • 2536
        • United States

        #4
        Re: Solar panel - circuit for recharge battery during the night

        Originally posted by nings
        Hello,

        I have already a controller for charge the batteries but these devices doesn't support external power.

        But thank you
        I did not realize that, as the controller should have these options. So as far as charging at night that is a easy thing. You would use a light detector and a relay. This is a simple way. There maybe better ways. So the light detector would be connected to a coil that closes a relay. The relay will be a single pole double throw and in one direction it will be Normally closed this is what one would connect to you your battery charger. The other would be normally open this is what would connect to the solar charger. So when the sun shines the light detector would be energized which energizes the coil of the relay and powers the closing of the relay of the solar charger. When the light goes down the detector would not energize and the charger for the battery would connect. I am sure they must have the same this in solid state relay which would have a comparator with some type of qualifier in a time delay so that the relay is not activated by momentary light and perhaps a controllable clock. I will look and see if I can find something. One other note on the relay is you want a break before make.
        Last edited by keeney123; 11-09-2016, 12:52 PM.

        Comment

        • keeney123
          Lauren
          • Sep 2014
          • 2536
          • United States

          #5
          Re: Solar panel - circuit for recharge battery during the night

          Here is a controller and if you read down to Auxiliary Generators it says you can connect other sources without disconnecting the solar charger.

          http://www.ecodirect.com/Morningstar...FRlMDQod0IAHTw

          So with this one you could put your power supply on a timer and plug the supply into the timer.
          Last edited by keeney123; 11-09-2016, 12:55 PM.

          Comment

          • keeney123
            Lauren
            • Sep 2014
            • 2536
            • United States

            #6
            Re: Solar panel - circuit for recharge battery during the night

            https://www.amazon.com/Woods-59408-O...h+light+sensor

            Here is one of many light detectors that controls a load of 500 watts.

            This one a 15 Amp light detector with timer.
            Last edited by keeney123; 11-09-2016, 01:04 PM.

            Comment

            • keeney123
              Lauren
              • Sep 2014
              • 2536
              • United States

              #7
              Re: Solar panel - circuit for recharge battery during the night

              Here is another way to do this put a solid state relay coming off of your solar controller. Have it energize when the solar controller is putting out energy. When the relay does not detect energy because the controller has shut down because of lack of voltage then have the deenergize relay make a connection to your power supply. If the power supply has stand-by mode when no load is connected then you can just leave the supply on all the time and it will only use milliwatts until the load is applied. Or the closed relay could connect the power supply to the AC. The power supply would have to have a regulator and a charging current detector so it would switch off when charging current stops. It could be done with power diodes.

              Comment

              • nings
                Member
                • Apr 2010
                • 13

                #8
                Re: Solar panel - circuit for recharge battery during the night

                Thank you keeney !
                You have great ideas

                I think to use two relays for connect the power supply to AC.
                One connected to a light detector for security and the second connected to the load of the controller.
                Load is cutted off when the batteries are lower than 2x.0V so I can connect the power supply to AC and put the power to the solar panel input directly like that a charger controller isn't needed. I have already one diode on the positive wire and one in the other side on the negative for not send power through the solar panel. The controller charge the batteries and wait to reach 2x.0V during some amount of time before open load. When load is open again, it's cut one relay off and the power supply

                It should work no ?
                I try to draw and simulate the circuit

                Comment

                • keeney123
                  Lauren
                  • Sep 2014
                  • 2536
                  • United States

                  #9
                  Re: Solar panel - circuit for recharge battery during the night

                  Originally posted by nings
                  Thank you keeney !
                  You have great ideas

                  I think to use two relays for connect the power supply to AC.
                  One connected to a light detector for security and the second connected to the load of the controller.
                  Load is cutted off when the batteries are lower than 2x.0V so I can connect the power supply to AC and put the power to the solar panel input directly like that a charger controller isn't needed. I have already one diode on the positive wire and one in the other side on the negative for not send power through the solar panel. The controller charge the batteries and wait to reach 2x.0V during some amount of time before open load. When load is open again, it's cut one relay off and the power supply

                  It should work no ?
                  I try to draw and simulate the circuit
                  If you draw it up I will look at it and also anyone else that see the post. So you should have lots of eyes on it.

                  Comment

                  Related Topics

                  Collapse

                  • Techie_hobby1
                    Help please with identification of few components for troubleshooting (Solar Water Fountain circuit)
                    by Techie_hobby1
                    Need some help please with a few components on this small board so that I can troubleshoot the circuit.

                    The PCB is a Single sided board fairly simple circuitry has a +ve and -ve Solar cell power input, a 7.4v 1500mAh (dual 18630 cell) power in which the Solar panel charges the cells, and lastly the Output goes to a DC connector...
                    J1 is actually 1P1T Switch (in ON position completes Battery cell circuit
                    J2 - to DC Output
                    J3 is Battery cell connector

                    however I am struggling to identify if:
                    Y1 (SOT-23) are NPN Transistors, MOSFET's or 11v Zener's....
                    07-24-2025, 12:43 PM
                  • Alimash
                    op amp circuit function?
                    by Alimash
                    Hi,
                    I am repairing a ups which doesn't turn on ,it has the following ICs:
                    SG3525 used to drive inverter mosfets.
                    couple of uc3483, one for the power supply and another to drive a big mosfet at the output stage(i think the technique is called boost)
                    A LM358 and TL074 for control mechanism and of course the uController.

                    The SG3525 is shutting down every time the ups is turned on.
                    I want your help to know the function of LM358 and TL074 in the system.
                    I reverse engineered the LM358 circuit and i think that one of the block(A) is used for battery level...
                    Today, 07:45 AM
                  • Astonished
                    Fixing the Charge Circuit of the Batteries of the DC Motor
                    by Astonished
                    Hi friends of electronics

                    What you see in the video and pictures attached is the circuit for charging the batteries of a DC motor.

                    The problem is that this circuit cannot charge the batteries (3 1800mAH NiMH batteries) any more. When the circuit was OK, its green LEDs lit up one at a time to show that the batteries have charged more. But now that the circuit is flawed, LEDs light up as you see in the video and at the same time successive beeps are heard.

                    Please help me fix this circuit.

                    (the datasheet of the IC: https://pdf.datasheet.live/28...
                    01-28-2025, 06:24 AM
                  • rddube
                    Lenovo L490 Ram voltage circuit malfunction
                    by rddube
                    Hello friends,

                    Looking for some guidance here. The RAM voltage circuit on this motherboard keeps burning out PU301 which is a RT8231AGQW. Copy of the board with the burnt chip attached with some voltage measurements and copy of the schematics also included.

                    I think I've checked almost every component in the circuit, but when I change the RT8231, the laptop starts I have 1.2V on the inductor for about 10 seconds and then the RT8231 goes south and no more voltage on the inductor. All other voltages on the laptop are good, this is the only one conking out for a reason I...
                    07-15-2025, 04:41 PM
                  • Tarot Superstars
                    Short Circuit tester
                    by Tarot Superstars
                    Hello.
                    I have seen a short circuit tester made with 3 * 9V batteries, a voltage limiter component and a resistor connected to the probes of a multimeter.
                    The theory is that the meter becomes sensitive enough to read very low resistances and the lowest resistance to ground on a circuit is likely to be a short circuit in that area.

                    Link
                    The Amazing $1 Short Finder Upgraded! Convert ... - YouTube
                    https://www.youtube.com/watch?v=0eixDdCpiO4

                    My multimeter isn't normally sensitive to very small resistance, but when I put a 1 mega ohm resistor...
                    09-25-2023, 09:11 AM
                  • Loading...
                  • No more items.
                  Working...