What tool do you recommend? Is the T56 good enough or should I get something else. I saw that EFI programmer but it was pretty pricey compared to the T56 and it didnt even have any adapters. I have a T48 but Im not seeing any emmc adapter for it.
-
-
There look to be eMMC chips in the T48 compatibility list. -
EMMC BGA five-in-one Adapter only for T48
https://aliexpress.com/item/1005005043000547.html
https://www.ebay.com/itm/195216197345Attached FilesComment
-
-
XGECU T48 or T56 and a BGA adapter. But you can also flash on board with flying wires. Look at my Dreamlink T1 thread. I had used an RT809H as a flash tool and the BGA adapter.Comment
-
it may depend on the chip number,
i recently found a flash that is locked in 4bit mode from the factory - so you must program it in 4bit mode - i assume.
it's 1.8v too, thats a problem for some programmers
Comment
Comment