hello guys. sometimes my CPU just freeze and i thinks that is no wrong software installation so i am looking around motherboard and
i just found that my motherboard has a bulged caps nearly the VGA card. it has a two bulged caps.
the question is that possible i am using my common soldering iron to changes the caps before my motherboard failed affected by that bad caps? i don't have a hot air on my tools. the caps is just like usual caps, not likes a SMD components need a hot air.. so i just wanna asking before replace it. i don't wanna makes my motherboard failed of course without knowing what i will do.
i don't know if my thread has a wrong place because i am new here.. excuse me please.
really appreciated any advice and suggest..
i just found that my motherboard has a bulged caps nearly the VGA card. it has a two bulged caps.
the question is that possible i am using my common soldering iron to changes the caps before my motherboard failed affected by that bad caps? i don't have a hot air on my tools. the caps is just like usual caps, not likes a SMD components need a hot air.. so i just wanna asking before replace it. i don't wanna makes my motherboard failed of course without knowing what i will do.
i don't know if my thread has a wrong place because i am new here.. excuse me please.
really appreciated any advice and suggest..

Comment