I wanted to know if anyone has a link to a good online retailer that can sell me the highest quality capacitors for my abit vp6. I was considering Panasonic, Sanyo, and or RubyCon... Dont know which is top brand..
Thanks,
CP
Thanks,
CP
-
-
Heres a link to a good online resource of Caps...
http://www.digikey.com
They have Panasonic caps. I just order some from them. -
Happen to know what the exact type is, the filter at digikey is a PITAOriginally posted by ShawninTennessee
Heres a link to a good online resource of Caps...
http://www.digikey.com
They have Panasonic caps. I just order some from them.
MDYa'll think us folk from the country's real funny-like, dontcha?
The opinions expressed above do not represent those of BADCAPS.NET or any of their affiliates.Comment
-
Hi, I have some 32 bits computer motherboards that need repair, as they fail to
power on.
Here are some examples :
(N.B. "capacitors" indicated here are electrolytic capacitors located in the onboard
switching supply area).
(N.B. #2 : I could not find a 3300 microF aluminum-polymer with a higher voltage
than 6.3 V.)
1 - Motherboard #1 : this is an Asrock K7VT2 (socket A) that still works well. To put it on test
I replaced capacitors with aluminum-polymer.
3300 microF/6.3 V. x 4 replaced by 3300 microF/6.3 V. (KYOCERA... -
I got this 55 inch AU7X00 TV, it was rebooting and showed no image only a blink of the backlights.
I assumed it was either panel or motherboard. Turns out it was the panel, and after applying some tape on the ribbon cable that goes to the left side of the screen, the TV turned on with image, then I suddenly noticed a dark spot and the pixels were turning black on the left edge, I was sad and thought I smashed the screen somewhere, found nothing visually, it looked in perfect condition and if it was there before it would've been noticeable while I was inspecting the TV the first time.... -
I have acquired a used Dick Smith Q-1760 power supply - although the OEM is Manson Industrial
It has at least one problem.
The voltage control potentiometer VR2, 50K is faulty - going high resistance / open circuit in the CCW end and leading to the output voltage jumping around.
I have already ordered a replacement potentiometer, so that's not an issue.
Now, I want to replace all three electrolytics on the PCB as they are CapXon and I don't trust them so much, I will replace them with something better while I've got the thing apart anyway.
All are CapXon... -
Hi,
I'd like to recap some of my old mainboards (they are from 1998) before switching them on again for the first time after many years in storage. All caps still look good from the outside.
There are three mainboards:
- ASUS P5A rev 1.04
- ASUS P2B-S rev 1.03 "Rubycon"
- ASUS P2B-S rev 1.03 "Chemi-Con"
If you are interested in their specs, The Retro Web has pages for the P5A and the P2B-S.
They all have many 1000uF 6.3V 105°C capacitors. But there are some differences I cannot figure out.
P5A
... -
hey all, iv got my favourite battery charger here which iv had for many years probably 15 years now or maybe even more. it still works good but thought id open it up to clean the dust out of it, lots of dust inside but now its clean and noticed 4 capacitors inside it and wondered if i should replace them.
it has inside:
2 x 47uf 16v caps 105c branded as Su'scon (lol sounds sus to me)
2 x 470uf 16v LZ105c branded as G.Luxon
not heard of these brands are they any good?
iv attached photos of the charger and the board inside for an idea on the type of...
Comment