Uh...oh...strange behaviour..

Collapse
X
Collapse
 
  • Page of 1
  • Time
  • Show
Clear All
new posts
Previous template Next
  • kiddznet
    Senior Member
    • Jul 2010
    • 176
    #1

    Uh...oh...strange behaviour..

    I have just finished recapping the bloated 3300uf 6.3v caps on a Epox DAE
    It sarted but the little BIOS LED display never went past the second value
    stopped it depowered and did the CMOS thing fired her up and was just about to give up when bingo it posted.
    Then after a run it shut it self off
    DEAD no fan no post nuthin
    Checked the soldering for dodgy dry joints all over redid the CMOS thing and it started
    I got the screen here CPU 47C Chassis 32C which is the current air temp
    I'll leave it run for a bit
    Any suggestions?


    939 DualCore AMD Opteron, 1800 MHz (9 x 200)
    Abit AN8 / Fatal1ty AN8 SLI Series
    3072 MB (PC3200 DDR SDRAM)
    ATI Radeon HD 4300/4500 Series (1024 MB
    Lian LI Aluminium mesh case
    Tags: None
    • kiddznet
      Senior Member
      • Jul 2010
      • 176
      #2
      Re: Uh...oh...strange behaviour..

      The MB 0is an EPOX DAI btw and its still running.....


      939 DualCore AMD Opteron, 1800 MHz (9 x 200)
      Abit AN8 / Fatal1ty AN8 SLI Series
      3072 MB (PC3200 DDR SDRAM)
      ATI Radeon HD 4300/4500 Series (1024 MB
      Lian LI Aluminium mesh case

        Comment

        • kiddznet
          Senior Member
          • Jul 2010
          • 176
          #3
          Re: Uh...oh...strange behaviour..

          Well darn...seems posting the glitch on this board fixed the problem...thanks for them magic Rubycons Mo...


          939 DualCore AMD Opteron, 1800 MHz (9 x 200)
          Abit AN8 / Fatal1ty AN8 SLI Series
          3072 MB (PC3200 DDR SDRAM)
          ATI Radeon HD 4300/4500 Series (1024 MB
          Lian LI Aluminium mesh case

            Comment

            Previous template Next

            Related Topics

            Collapse
            • questore
              XPS 13 9370 CMOS battery voltage always low
              by questore
              Hi Everyone,
              I have brought you a mistery item
              This laptop have come with some strange faults.
              1. CMOS battery was flat 0v
              Symptoms:
              - After using the laptop and shutting down and removing the AC adapter for at least 1 minute, the laptop never turned on until EC reset (either shorting RTC or removing battery and long pressing power button)
              Amp drawing was stuck at 0.005 milliamps.
              - Laptop cannot really be turned off because it autostarts about 5 sec-1 or 2 minute. (lid sw is not the problem)

              After inverstigation RTCD1 diode had a low value...
              09-30-2025, 05:47 AM
            • Ariu
              Hp 15-n267sg Strange behaviour CMOS reset (502) , not a battery fault!
              by Ariu
              I have a problem with an hp 15-n267sg .
              The device was not turning on because a faulty superIO.
              After replacing the ITE chip it's working fine but the bios not at all, date and time keeps restarting (00:00:00 /01.01.2013)
              and I am not able to make any bios settings change...
              I didn't see this kind of strange behaviour on other devices , superIO is soldered properly and tried different bios dumps but same...

              The CMOS battery is ok , what else can cause this?
              Please help.
              Thanks
              11-30-2021, 04:56 PM
            • Federause
              HP 250 G7 - Battery Issue (Lid behaviour)
              by Federause
              Hi everyone,
              I have an HP 250 G7 for assistance. I've changed the battery (the old was dead) with a not-original.
              It has a particular behaviour that I've never seen:
              With the lid open, the voltage is present on the relative pins. Upon a time I close the lid, after 5-10 sec. the voltage drops down to 0. If I re-open the lid, the battery keeps stuck in this situation. I have to connect the power supply to "resurrect" the battery. In this way, I can power on the laptop without any problem and also use it without the power cord. If i shutdown the laptop, keeps it with the...
              09-08-2024, 03:34 AM
            • dqtech
              lenovo thinkpad t420 wont turn on when cmos battery attached
              by dqtech
              please help...this lenovo thinkpad t420 early problem is short 19v...after replace short capacitor all working fine...but, when i attach cmos battery on motherboard this laptop wont turn on, power button not respond....it only work without cmos battery....power button and cmos battery is in good condition...i try replace new cmos battery but problem still persist...any idea?...
              06-16-2023, 03:56 AM
            • magistertc
              CMOS battery drains quickly
              by magistertc
              This problem is based on my experience with an ASUS Z390 Prime motherboard, but it appears to affect other motherboards
              as well Install a new CMOS battery, configure computer, turn off computer and disconnect from AC power or switch off SMPS.
              Return somewhat later and find that battery is drained, dead, or weak. Clock is wrong, other settings lost, etc.

              Examine the power 'sharing' circuit -- when the ATX 3V supply is on, the computer will function normally. The computer is also
              configured to support the RTC and some volatile RAM (when SMPS is on). What you may...
              07-06-2024, 09:55 AM
            • Loading...
            • No more items.
            Working...