Sharp 70 inch TV LC70EQ1OU NO /picture/no sound

Collapse
X
 
  • Time
  • Show
Clear All
new posts
  • jay08210
    New Member
    • Feb 2022
    • 2
    • United States

    #1

    Sharp 70 inch TV LC70EQ1OU NO /picture/no sound

    Hello ALL Helping Techs,

    So, this is what my problem is for
    Sharp 70in Aquos Liquid Crystal TV
    TV Model # LC70EQ1OU
    Audio/Video input board= bar code is #G38101A0210406881402181XS, no other labels present.

    1. TV goes blank in front of my eyes, it turned on and then went bark.
    Now 2 weeks ago I was not getting volume out of tv even after unplugging all inputs but HDMI slots.
    My Bluetooth soundbar was working, so I was not overly worried about it, I just had to do a master reset. But before sound bar and tv volume was working fine.
    2. But the master reset from YouTube didn't work on my tv. And I could not find the master reset on the tv nor was it in the manual? So that's when everything went blank.
    3. I have tried all the known reset (youtube) as my power-on light was just blinking, so I went to SharpUSA Facebook page and instant message them. I got the correct reset button from him which was (Down channel button plus /volume up) Now this was better as I did not have to have my wife helping me.
    4. So, it worked so much that the power light now stays on till it times out. As I now have it hard reset, I am unable to see anything, to do anything. So, after I took off back of tv it reminded me of my computer support work I used to do and went to school for. So, feel I can fix it myself, with some help.

    5. So, I have a green light that comes on and blinks on the Audio board, but only after I hard reset each time. Then I unplug each ribbon cable and the green light does not come on. So, the circuit is broken doing that.
    6. My question is do I replace the audio board, or do I have to go do the dreaded replacing backlight strips, or does an LCD have strips? As far as I can see there is at least 30 screws I may have to take off to get to the backlight strips. But today I get my led voltage tester for backlight and system boards. To better trouble shoot TV.
    What voltage should i be lookin for.
    7. I am sending pictures of system and the green light. Any and all input is greatly needed.

    Thank You in advance
    Jay (Retired Disable Veteran)

    PS: Of course, everyone wants you to either throw it out and get a new one. Or see a tv repairman. You now need a 7-year warranty for these tvs.as a minimum.
    Attached Files
  • nomoresonys
    Badcaps Legend
    • Jan 2013
    • 12206
    • U.S.

    #2
    Re: Sharp 70 inch TV LC70EQ1OU NO /picture/no sound

    good place to start is here, to see if you are getting the needed voltages: https://www.youtube.com/watch?v=4v8DcqCNG4A

    Comment

    • nomoresonys
      Badcaps Legend
      • Jan 2013
      • 12206
      • U.S.

      #3
      Re: Sharp 70 inch TV LC70EQ1OU NO /picture/no sound

      report the voltages you have in standby(tv plugged in) and when you power on the tv, report both conditions, as in: pin number, expected voltage and your actual voltage, example pin 1 ps-on, off 0volts, on 3.5volts.

      Comment

      • dskall
        Badcaps Legend
        • Oct 2016
        • 2905
        • usa

        #4
        Re: Sharp 70 inch TV LC70EQ1OU NO /picture/no sound

        A good visual inspection and voltage checks. Suspect maybe a firmware problem.
        I assume no responsibility for any stupid suggestions I might post.

        Comment

        Related Topics

        Collapse

        • TR103
          Samsung TV model UE50TU: rebooting, backlight, sound, but no picture
          by TR103
          Hi, I have a Samsung UE50TU with:
          - sound and backlight, but no picture
          - when it arrived, it had a picture for a few seconds
          - it keeps rebooting
          - without ribbon cable between the two panel boards, it does not reboot but I have no picture
          - without cable between mainboard and lcd panel, it does not reboot (but obviously i have no picture)
          - when i try a tape fix, its keeps rebooting, unless I tape off pin 1 (the innermost pin). In that case it does not reboot but I have no picture.

          - without cable between mainboard and lcd panel and with a jumpered...
          01-22-2025, 04:12 PM
        • Mgiffune
          Samsung UN60EH6000F Black Screen, Backlight and Sound Good. Power Cycle Returns Picture
          by Mgiffune
          I have a 60 inch Samsung UN60EH6000F flatscreen TV. The screen went black a few months ago Sound is good, backlight is good, no menu. I replaced the TCon board with a used board purchased from Ebay. It worked fine for a 3-4 months, then the screen started ‘fading' back. Once again, sound is good, backlight is good, no menu. However, this time the picture looks fine for about 10-15 minutes, then fades back. If I power cycle the TV, the display reappears, for another 10-15 minutes, then fades black again. Repeatable ever time.

          I ordered a supposedly ‘new' Tcon board this time, and
          ...
          06-09-2024, 10:28 AM
        • Ierwin
          Samsung UE60KU6079 backlight okay mainboard responsive, no picture, no sound
          by Ierwin
          Hello everyone,
          Ive got a UE60KU6079 on the workbench that is giving me some headaches trying to troubleshoot.
          The previous owner stated that there had been white dots on the screen which from the description sounded like some lenses fell of the backlight LEDs.
          He had opened the TV from the back, trying to get to the backlight, supposedly gave up, reassebled everything and gave the TV to me.
          I expected the worst like ripped COF cables or a cracked panel but could not find anything like that yet.
          Anyway I still fully expect that there has been something seriously damaged...
          05-13-2025, 03:31 PM
        • jchang
          Samsung UN70NU6900F no picture and no sound
          by jchang
          Hi all

          I was just given a Samsung TV with the issue. I read various threads and videos and attempted the ribbon tape method to gain an image, but no luck.



          Symptom:
          No picture no sound.
          When I plug in the power cord, Backlight LED turns on for a half second and then turns off. The red LED next to the power button located center bottom flashes 2 or 3 times. When the power button is pressed after, it does the same thing.
          No sound at all.



          What I tried:
          1. I tried unplugging the left or right ribbon...
          01-09-2023, 06:28 PM
        • ChaosLegionnaire
          what i went through dealing with my mobo with dead onboard sound!
          by ChaosLegionnaire
          so i took out one of my spare gigabyte ep35-ds3r mobos from storage for use to do some cpu, ram and video card testing of stuff i bought from ebay and got for free from momaka. he bought 50 e8400 cpus for cheap from ebay some years ago and i decided to help him relieve him of some of his supply since he had waaaay too many!! what did we say about hoarding too much stuff and depriving others of them?! *cough* socialism *cough* lol!

          i had to blow some dust off the board and heatsinks with the datavac as i didnt clean it up before putting it in storage. after finishing...
          09-13-2022, 09:02 AM
        • Loading...
        • No more items.
        Working...