Westinghouse WD40FW2610 hard reset?

Collapse
X
Collapse
 
  • Page of 1
  • Time
  • Show
Clear All
new posts
Previous template Next
  • MikeRWK
    Senior Member
    • Jun 2017
    • 121
    • Canada
    #1

    Westinghouse WD40FW2610 hard reset?

    Are there any points on this board I can short to hard reset this TV? It won't save any tcon settings in the service menu.
    Attached Files

    if you find these attachements useful please consider making a small donation to the site

    Tags: None
    • dick_barton
      Badcaps Legend
      • Aug 2015
      • 6643
      • Wales
      #2
      Re: Westinghouse WD40FW2610 hard reset?

      I think on some sets when you change things you have to switch off and it is saved the changes when powering down.
      Willing to help but I'm no expert.

        Comment

        • MikeRWK
          Senior Member
          • Jun 2017
          • 121
          • Canada
          #3
          Re: Westinghouse WD40FW2610 hard reset?

          Originally posted by dick_barton
          I think on some sets when you change things you have to switch off and it is saved the changes when powering down.
          Its not saving when I power down and there doesnt appear to be an eeprom, so I'm guessing the flash chip is bad.

            Comment

            Previous template Next

            Related Topics

            Collapse
            • odie34
              Sony OLED XR-77A80J - 5 Flashes But Turn On After Hard Reset
              by odie34
              I am a hobbyist (not a professional) so please be gentle...

              I recently received an XR-77A80J that wouldn't turn on. (Repeating 5 flashes when plugged in.)

              I did a hard reset by holding the power button for about 30 seconds until the set powered down. I then tried to turn it on and it powered up, bringing me to the setup screen. There's not a lot of detail on the setup screen but the picture didn't have any distortions, so at least a cursory examination suggests no physical damage to the screen. The set appeared to be working normally, but it shut down after about 15 seconds,...
              02-18-2024, 09:11 AM
            • Conste
              Clevo W25CEW doesn't save Bios settings / shutdown issue
              by Conste
              Hello together,

              I have a Clevo W25CEW (Terra 1541) with some strange symptoms:

              1. I cannot save Bios settings by pressing "save settings" in the bios. By pressing "save & exit" it will save the settings.

              2. I can boot normally (UEFI installation), but when I shut the machine down and start it after a few seconds again it will show resume from hibernation and shutdown after POST, just before windows would boot. Then it will go back to factory settings and my UEFI installation will not boot!

              Already changed the CMOS battery...
              09-01-2021, 10:34 AM
            • YG007
              Asus BIOS How To Reset To Default Settings?
              by YG007
              Hello... Where do I start. I have 2 questions/scenarios that might bring this laptop back to life, so here it goes!

              I have this laptop (Asus UX52VS) where I was flashing the BIOS to it and it froze during the process. I didn't have a reliable BIOS chip programmer at the time (It was a CH341A USB Programmer from Amazon where it took hours just to get the clamp on the chip and then every time I read, it gave me different results/corruption, and never would pass the verify test as no 2 reads were the same data), so I brought it to a shop. They had it for almost 2 months, but during...
              06-05-2023, 08:22 PM
            • sheffieldyorky
              ZAB/ZAB A,B/ZYJA BLOCK DIAGRAM Acer Aspire
              by sheffieldyorky
              Hey there people
              While working on my Acer Aspire with the OS failing to load, I encountered a motherboard number of DA0ZHQMB6E 0 REV: E. I was getting nowhere fast or slow, for that matter.
              This is what I tried, but not in any order.
              Google
              YouTube
              BIOS
              Command Prompt (administrator privileges)
              >
              On Google AND YouTube, I was getting mixed messages, try this and try that, but when you cross reference the advice it is either the wrong model (even though you enter the correct search term) a YouTube case in point, with the search term "how to...
              10-25-2025, 02:22 AM
            • RetroComputingGrotto
              New Toy UNI-T UTi260B - What Settings?
              by RetroComputingGrotto
              I've literally just received in the post a UNI-T UTi260B (it's currently on charge).

              After quickly scanning the user manual I see there are all sorts of configurable settings (Measurement settings, Palette settings, Point temperature settings and Image Mode). As this is my first Thermal Imaging Camera I have no idea what all these settings are nor if I need to change/configure any of them.

              I intend/hope to use this to help me diagnose issues with laptop motherboards so should I just leave the settings as the default or is there someone out there with a UNI-T thermal...
              09-02-2025, 08:36 AM
            • Loading...
            • No more items.
            Working...