Samsung-UN39FH5000FXZA-Will Not Turn ON

Collapse
X
 
  • Time
  • Show
Clear All
new posts
  • cherokee.warrior
    Senior Member
    • May 2017
    • 87
    • United States

    #1

    Samsung-UN39FH5000FXZA-Will Not Turn ON

    I have tried all that was listed on the following link

    https://www.badcaps.net/forum/showth...un39fh5000fxza

    the reading i get on cnm803 connector on the power supply are as follows:

    b13v 12.9v
    b13v 12.9v
    vamp 12.9v
    vamp 12.9v
    gnd 0
    b5v 5.3v
    b5v 5.3v

    pwm_dm 3.2v
    b13v 12.9v
    blu on/off 2.9v
    gnd 0
    gnd 0
    a5v 5.3v
    pwr on/off 2.3v

    If i completely take the connector running to the main board off the leds will come on. If i leave the main board connected and disconnect the tcon board the led lights will not come on. If i take the bl wire loose the backlights will not come on. im getting no sound, no picture, no backlights accept when the cable from the pwr supply to mainboard is disconnected and no standby light if this tv has one.

    I have replace ic 901 on th main board from shopjimmy and it had no effect. I started checking for shorts to ground and found some. They are show in one of the pictures i have posted. the arrows point out all the caps and im sure other items that had ground readings on both sides. I found the ic i replaced had some connections to ground that i don't think there should be.

    Is there a service manual to be had for this tv or some schematics of the main board so at least i can know the values of what might need to be replaced.
    Attached Files
  • alfatv
    Badcaps Veteran
    • Sep 2020
    • 353
    • Canada

    #2
    Re: Samsung-UN39FH5000FXZA-Will Not Turn ON

    I know, we all here like to fix things, but it may be less hassle to get used board on eBay.

    Comment

    • neilc6
      Badcaps Legend
      • Nov 2015
      • 1550
      • Canada

      #3
      Re: Samsung-UN39FH5000FXZA-Will Not Turn ON

      Very difficult to repair main boards especially since schematics are typically not available. I have never seen a Samsung main board schematic, only Philips or Sonys from service manuals online. Your PS voltages all look correct. TV not turning on could be EEPROM but you replaced that already. Other than that, you can check any on board regulators. Caps may be used for filtering so you can remove if you find them shorted but there are likely many on the same power rail and it may take time to isolate the correct one.
      Last edited by neilc6; 06-05-2021, 08:01 PM.

      Comment

      Related Topics

      Collapse

      • Dani_2024
        Sceptre U550CV-UMR 4K LED, Bad Caps on Main Power Board?
        by Dani_2024
        Hi and thanks in advance for any input you might provide!
        I have a Sceptre U550CV-UMRD8POTV83BB 4K LED (this is a dumb tv) that I bought new in August 2021, so It's just completed 3 years.
        Main power board model: TP.MS3683.PC821 T-Con board: N4TP546UHDPU2L_BO

        Last Sunday I was watching a dvd and fell asleep for about half hour, when I awoke the tv screen was black and couldn't get the dvd menu to show, so I changed the input to antenna and had sound but no picture, turned it off. I then got online and found this great site! ....read many troubleshooting tips and this...
        10-28-2024, 05:06 PM
      • ygorsan
        LG 55NANO77SRA TV – Menu scrolling by itself even after removing button board (Main Board EBU66792103)
        by ygorsan
        Hi everyone,




        I’m looking for help with a persistent issue on an LG TV model 55NANO77SRA, which uses the main board EBU66792103 (also used in LG UQ80 and NANO75/NANO80 series).







        🧩 Problem Summary:
        • The TV keeps scrolling through the menu or selecting items by itself.
        • I removed the physical button board (the entire panel with power and volume buttons) and also disconnected the flat cable (CN202) from the main board.
        • The remote control is not in use (batteries removed), and the TV still shows the same behavior.
        • I
        ...
        07-28-2025, 08:34 AM
      • jb_Bak
        Sony xbr-65x900c main board issues?
        by jb_Bak
        Hey guys great forum glad to have found it. I bought a Sony XBR 65X900C cheaply because it didn't work. No signs of life at all not even a light/led. All I hear is a brief high voltage sound when I throw the power to it.

        Didn't see any obvious signs of damage so right away started checking voltages. This is what I see:
        Power Board Connector that goes to Main board
        CN6401
        Pin 01 NC
        Pin 02 NC
        Pin 03 "BL_ON": 0V
        Pin 04 "N/C"
        Pin 05 "STBY 3.3V": 3.5V
        Pin 06 "GND": N/C
        Pin 07 "AC_OFF"...
        09-27-2021, 04:52 PM
      • JDC
        (SOLVED) - ONN 100012588 No Power, Then Rebooting After Main Board Change
        by JDC
        ONN 100012588
        Issue: No Power, Then Rebooting After Main Board Change

        Short answer: replace main board and power board
        Technical answer: replace main board and Q306 & Q307 on power board.

        Long answer:

        TV wouldn't turn on. Power switch was fine which means the main board isn't processing the power on signal. Replaced main board. TV turns on now but randomly reboots. Bad main board? EEPROM? Tried to pull main board and got a shock touching the corner of the board. That's weird. C334 (450V 10uf) capacitor is still holding a high charge....
        07-15-2022, 07:39 AM
      • m1ch43lzm
        HP Pavilion 15-eh Board DAG7HAMB8F0 - CPU throttling to 0.4GHz (PROCHOT_EXT) and black screen
        by m1ch43lzm
        Hi, this is my personal laptop, which the original board (lets call it Board A) blew up PU8700 (TPS51486), making a hole on the board, i had left the laptop at my desk one day with the battery fully charged and didn't touch it for a week, but when i tried to turn it on it didn't
        Thought the battery was dead, so i plugged in the charger then tried to power on, the power LED blinked once, charged LED still orange, unplugged the charger, plugged in again and I noticed the "magic smoke" smell, so i unplugged the charger, removed the back cover and saw the blown IC (the "magic...
        05-12-2025, 08:37 PM
      • Loading...
      • No more items.
      Working...