Announcement

Collapse
No announcement yet.

Samsung UA65

Collapse
X
 
  • Filter
  • Time
  • Show
Clear All
new posts

    Samsung UA65

    Hi Guys
    Got a samsung UA65ju6000 (possibly UN65 ) set is dead if i remove thw plug between Main and power boards, the LEDS light up.

    With that plug out the voltage coming from the PSU is 13 volts (as printed on the board. When I plug in the main board this voltage drops to 9 volts.
    Also , There is no stand by light .and i cannot find a 3.3 volt anywhere on the board. I also find that D201 meaasures short circuit.

    I reckon the fault must be the Main Board. but any input will be greatly appreciated

    Thanks James

    Power board is BN44-00805a and Main board is BN94 09544B

    #2
    Re: Samsung UA65

    Some pictures of your circuit boards would be helpfull. Is D201 on the main board or power supply. If on the power supply then I would replace it and then check your voltages again.
    The 3.3V could be coming back off the mainboard.
    Willing to help but I'm no expert.

    Comment


      #3
      Re: Samsung UA65

      Thanks for the reply.

      The diode is on the main board

      Comment


        #4
        Re: Samsung UA65

        Can you post some nice sharp pictures of your power suppy board and the mainboard showing where D201 is located.
        Willing to help but I'm no expert.

        Comment

        Working...
        X