You could also check if the spindle motor spins freely, if the motor does'nt spin properly it can show this type of problem, especially when the motor needs to run at a slower speed.
I found out with my Toshiba DVD video player Model no. SD3005KB-2 works properly, when I take the lid off, the top lid, when I put it back on it states bad disc, it spins with the round thing making red lights and clicking noises.
More information here found out the caps are ZHN and KSD!
If I clean the disc with isopropyl alcohol then it plays, I left all the cables unplugged overnight then it works a bit better. I put sewing machine oil on the pulley part of metal.
Is the other end damaged ?
The length is required, the pitch and number of contacts and also if they are on the same side or opposite (forward/reverse).
You could always trim off the damaged part and sand back the insulation if there is enough slack in the cable.
That cable looks perfectly fine, if the cable was bad the dvd would not work at all. The only way that cable would go bad is if you damaged it in some way.
Is the other end damaged ?
The length is required, the pitch and number of contacts and also if they are on the same side or opposite (forward/reverse).
You could always trim off the damaged part and sand back the insulation if there is enough slack in the cable.
How do you sand back the insulation to the metal pins ?
check out your local motor factors for electrical cleaner spray . then check whats in it . stuff i get is 97 percent isopropyl .and its cheap to buy . yellow can
check out your local motor factors for electrical cleaner spray . then check whats in it . stuff i get is 97 percent isopropyl .and its cheap to buy . yellow can
Comment