150uf at 450 wv Large Capacitor Blown - I've Never Seen This... Have you?

Collapse
X
 
  • Time
  • Show
Clear All
new posts
  • barryra
    Senior Member
    • Aug 2013
    • 107
    • USA

    #21
    Re: 150uf at 450 wv Large Capacitor Blown - I've Never Seen This... Have you?

    Originally posted by tvtimmy
    Hot air or a real soldering jron? If its real just melt some new lead free solder on it and then reheat each leg and pull them out with a wiggle.
    It's an real soldering iron. Ok, I'll try that. Thanks much! I appreciate it

    Comment

    Related Topics

    Collapse

    • MeetingIncapable
      Blown capacitor repair on MSI Radeon RX 5700 XT MECH OC
      by MeetingIncapable
      Hello,

      I am new to repairing computer electronics, so excuse any mistakes I make.

      A friend of mine had a broken graphics card (MSI Radeon RX 5700 XT MECH OC) and gave it to me. It does not power on or show any signs of life.
      I identified what looks like the remains of a blown capacitor at the bottom of the board (see picture).

      I wanted to replace the capacitor, but I have two questions:
      • Does this repair have a chance of working? or is a blown capacitor a sign something else is wrong?
      • How do I determine the rating/value of this capacitor? or something
      ...
      05-04-2024, 09:56 AM
    • NuclearSpartan
      Samsung C32HG70 - Blown Ceramic Capacitor (CP813)
      by NuclearSpartan
      Hi everyone,

      I'm new to this, so I apologize for not providing enough details. Is there anything else I need to mention? I'm trying to learn more about electronic/board repairs and hopefully fix my own.

      The only visible issue on my board is one capacitor, CP813, which appears to be labeled R 221k 2kV (possibly obsolete to B 221k 2kV now). My monitor hadn't shown any prior issues, although it is a few years old. Just before the capacitor popped, there was a high-pitched squeal for 2–3 seconds.

      I don't see any other visible damage anywhere else on the board....
      11-14-2024, 02:32 PM
    • Prolog
      RTX 3080 FE Identifying capacitor
      by Prolog
      Hi people, I hope this is the correct spot to post this, I'm new to the forum.

      I have an RTX 3080 Founders Edition which has a burnt up capacitor (it was in parallel with another capacitor which appears damaged too), so I am hoping to be able to identify the capacitor values and order replacements.

      I hope these photos make it clear which component I am referring to:
      (yes, the soldering is a bit botched from removing the blown one, I know)

      I have found the board schematic (attached), but there does not seem to be a boardview available. I have never...
      12-01-2024, 08:27 PM
    • chth96
      If I replace with inferior capacitor, Is it No harm to other IC components at all?
      by chth96
      I replaced some capacitor which is located on optical pickup pcb which is shown in the table below(PCB #2).Because it have been out of order.
      Now,It works very well,But I just have found that all caps (6svpc100my and other part number as well) ,which is shown in the table below, has ultra-high ripple current spec.
      It is not able to obtain any capacitor which can be a substitute for this ultra-high ripple current nichicon capacitor.
      So I replaced it with samxon and rubycon's general capacitor(GP,YXA series).
      I know that these capacitor will not last as long as nichicon capacitor...
      12-22-2023, 04:34 AM
    • cmlewis89
      LG 47LB5DF blown power supply board
      by cmlewis89
      Hi folks,

      I'm new to this forum. So my trusty 17-year-old LG 47" LCD recently died. As I was booting it up, I heard a hum followed by a loud bang, sounds of pieces flying around, and loss of power to the unit. Inspecting the PSU, I saw two obvious problems: a blown thermistor (bang + flung pieces) and a visibly bulging main cap. Inspecting as many components as I could with my Fluke MM, I diagnosed that the following components on the "hot side" of the board were also bad: one of the 2 main MOSFETs, main 8A fuse, small cap (25V 47uF) connected to main caps, and a blown...
      09-03-2024, 07:50 PM
    • Loading...
    • No more items.
    Working...