Here are my pictures and voltage readings. I get a brief "SONY" logo and then pic goes black. It doesn't seem to pass the flashlight test but I'm wondering about that as I'm using my phone and the light might not be bright enough.
I'm thinking I have a bad backlight as there is voltage on BL-ERR but not sure how much voltage is needed to trigger the protection circuit.
cn6401
1. 3.3 Tcon-on
2. 12.4 T-con vcc12v
3. n/a NC
4. 1.7 Dimmer
5. 3.1 BL-ON
6. 1.7 BL-ERR
7. 12.4 REG12v
8. 12.4 REG12v
9. 0 REG12vGND
10. 0 REG12vGND
11. 0 AudioGND
12. 12.4 Audio12v
13. 3.3 Power On
14. 3.1 AC Off DET
15. 3.3 STBY3.3
cn6402
1. 25.19 UNREG24V
2. 25.19 UNREG24V
3. 25.19 UNREG24V
4. 25.19 UNREG24V
5. 25.19 UNREG24V
6. 0 GND
7. 0 GND
8. 0 GND
9. 0 GND
10. 0 GND
11. 1.7 BL-ERR
12. 3.1 BL-ON
13. n/a NC
14. 1.7 Dimmer
I'm thinking I have a bad backlight as there is voltage on BL-ERR but not sure how much voltage is needed to trigger the protection circuit.
cn6401
1. 3.3 Tcon-on
2. 12.4 T-con vcc12v
3. n/a NC
4. 1.7 Dimmer
5. 3.1 BL-ON
6. 1.7 BL-ERR
7. 12.4 REG12v
8. 12.4 REG12v
9. 0 REG12vGND
10. 0 REG12vGND
11. 0 AudioGND
12. 12.4 Audio12v
13. 3.3 Power On
14. 3.1 AC Off DET
15. 3.3 STBY3.3
cn6402
1. 25.19 UNREG24V
2. 25.19 UNREG24V
3. 25.19 UNREG24V
4. 25.19 UNREG24V
5. 25.19 UNREG24V
6. 0 GND
7. 0 GND
8. 0 GND
9. 0 GND
10. 0 GND
11. 1.7 BL-ERR
12. 3.1 BL-ON
13. n/a NC
14. 1.7 Dimmer
Comment