Funky colors on a Sanyo DP50710

Collapse
X
Collapse
 
  • Page of 1
  • Time
  • Show
Clear All
new posts
Previous template Next
  • hardfahrer
    New Member
    • Jun 2015
    • 9
    • USA
    #1

    Funky colors on a Sanyo DP50710

    I recently put a used SC board in a Sanyo DP50710 and got it to turn on where it would not previously. I pulled up two sample pictures that the set has factory installed and the pictures were not sharp and the color was not right. (See attached pics) I am very novice with this and could use any help in determining what the problem might be and how to go about fixing it. Thanks in advance.
    Attached Files
    Tags: None
    • mmartell
      Badcaps Legend
      • Oct 2013
      • 3189
      • Canada
      #2
      Re: Funky colors on a Sanyo DP50710

      Not sure if that's still a ysus fault or other. But lookup how to run the internal test patterns to rule out the main board being the cause.

        Comment

        • dick_barton
          Badcaps Legend
          • Aug 2015
          • 6643
          • Wales
          #3
          Re: Funky colors on a Sanyo DP50710

          Have you measured all the voltages as given on the PDP panel and do they match.
          Willing to help but I'm no expert.

            Comment

            Previous template Next

            Related Topics

            Collapse
            • bohaboha
              Samsung UE70TU6905 BACKLIGHTS AND SOUND ON NO PICTURES BUT SCREEN NOT DARK
              by bohaboha
              Hi it looks like everything works don't know where to test except the 390v in the 2 capacitor in the hot side of the power supply and the weird 180v in the diodes in the cold side that should be discharged it is writin on the circuit no more you can read what is written on the circuit quite srrange color mixiing yellow and white
              anyhow i couldn't t read anything else
              the backlight is on strong and the screen does not get dark or very dark but no pictures
              the mainborad feels a bit hott on the black part i test it to 52 degree's against 34 to 40 on the rest of it
              ...
              01-02-2025, 08:04 PM
            • silikon77
              Philips 70PUS7855/12 bad colors when applying the tape fix on teh T-con board
              by silikon77
              Hi!
              Got an 70 inch Philips tv model 70pus7855/12 from scraps and I decidet to give it a go. I'm an enthusiast but no porfessional in the electronics.
              Found some advices watching youtube nad came up with this:
              It came with no picture, after diagnosing it I found out that the right side of the T.con board was faulty.
              I taped down the clock signals and I got a picture but the left side of the panel has less pronounced colours. Only the right 3rd side of the panel has good colors.
              See attached picture.

              I tried a few combinations to block individual clock...
              1 Photo
              01-02-2025, 02:26 PM
            • valvashon
              LG 55UH6150- trouble powering up, then half lit screen (pictures!)
              by valvashon
              The 55" LG has been in the basement for a few months without being used. Turned it on yesterday, set came on as it should and showed a complete screen for about 5 seconds (was on a broadcast channel but no antenna was connected), then the screen went mostly dark with about 1/3 of the screen on the right lighting up with brighter lines in that lit part (sorry, no pictures of that). Power LED was cycling too, preventing the TV from fully powering up.
              Pulled the back off, all boards looked OK. Pulled the LED connector, turned the set on to see if it would power up but I don't belive it...
              11-24-2024, 12:08 PM
            • cj_reha
              Mystery 80s Sanyo cap - perhaps polymer?
              by cj_reha
              Hey all I've been working on a 1984 Sanyo 27" color TV which had a smattering of bad caps in the video switching circuit. I found this oddball little 1uF 25V cap which looks to me like an early polymer, but I can't find concrete info proving it. I know Sanyo was a big player in early polymer cap development and this is the time period where they were just getting on the market, so I'm wondering if anyone has crusty old datasheets that could help identify it and determine if my suspicions are right? It has the same epoxy end seal and font/formatting as some old stock Os-Cons I've got laying...
              01-06-2023, 09:24 AM
            • kca
              LG 82UN8570AUD ~ TCON or PANEL?
              by kca
              Hello all ~

              Hope this finds you well. This LG 82UN8570AUD (April 2021 model) 4K UHD television has full audio capabilities but video is compromised / problematic.

              When I picked up this large LG tv it had a full black screen upon startup. Previous owner said it just went black one day. No popping sound or anything else of note.

              I got the display to work by taping off several traces of the right-hand side ribbon cable on the TCON that leads from TCON to PANEL. However, despite dozens and dozens of attempts to find the right combination / range of traces taped...
              08-31-2025, 06:38 AM
            • Loading...
            • No more items.
            Working...