LG 55le5400-UC AUSWLHR No backlight

Collapse
X
Collapse
 
  • Page of 2
  • Time
  • Show
Clear All
new posts
Previous 1 2 template Next
  • 0S1R1S
    Member
    • Mar 2014
    • 48
    • USA
    #21
    Re: LG 55le5400-UC AUSWLHR No backlight

    Just want to say that I came across this set as a freebie and couldn't figure it out, until I saw this posting. Went through the reflow process and 40 minutes later I have a working set. Tested for a few hours with PS4 gaming and didn't see any issues.

      Comment

      Previous 1 2 template Next

      Related Topics

      Collapse
      • howardc64
        Vizio E55-F1 dark backlight zones. LED failure or Dimming Zone Driver?
        by howardc64
        Problem

        Fixing a dimming zone TV with LEDs not lighting up. Dimming zone circuit introduces added variable to diagnose LED and/or Dimming Zone Driver board? Some 1/2 rows of LEDs appears to be out in active dimming zone off AND some brightness flickering with active dimming zone high while playing changing video



        Model & Board Pics



        Conflicting Spec

        Vizio indicate this TV has 10 dimming zones. However, LED strips and Zoned light driver connector suggest 12

        https://www.shopjimmy.com/vizio-gj-2k1...
        10-10-2024, 01:16 PM
      • DanPoka
        Guide me through repairing a Dell p2210f LCD ccfl backlight monitor
        by DanPoka
        I bought this p2210f dell monitor to fix. Schematic is the same as p2210.
        Behaviour is that monitors comes on but then backlight switches off almost instantly. If I look with flashlight I can still find the "No signal message". So definitely a backlight issue. Trying to advance the issue I proved that the protection circuit is switching off the backlight by shorting out C3 and resistor to disable the INL chip then re enable by removing the short.
        This is where it gets interesting. When I disassembled the monitor to solder leads on c3 capacitor I noticed the backlight flickered...
        02-15-2025, 05:05 AM
      • Comp_Pro
        No Backlight Macbook A1990 820-01041
        by Comp_Pro
        Hello all,

        Am trying to figure out this backlight issue with this A1990 Macbook Pro.

        Tests performed:

        There is no backlight even with a good screen.
        Backlight IC is receiving the correct support voltages.
        Fuse F8400 ok
        Current sense resistor R8400 ok
        Backlight IC is receiving 3.3V on enable pin.
        Backlight IC receiving voltage from PPBUS_G3H, aprox 12.5V.
        Backlight IC receiving 5V from PP5V_G3S
        Backlight IC BKLT_SCL and BKLT_SDA both measure 0.545V diode mode to ground
        I2C_BKLT_SCL and I2C_BKLT_SDA both measure...
        05-06-2024, 10:23 PM
      • canadaboy25
        LG Flatron 24EN33TA No Backlight When Cold
        by canadaboy25
        Hi all,

        I've got an LG Flatron 24EN33TA with a backlight issue. The problem began with the monitor not powering up after sitting for a long time (overnight or during the day throughout work). When I would wake the computer up, the backlight would flick on for a second then go out. Sometimes it would take many tries to get it to come on. Once the monitor came on, it worked flawlessly until another long duration of being powered off.

        I thought the problem would be bad caps but I checked both of the caps on the board and they are fine. I also tried powering the monitor from...
        03-07-2023, 12:23 AM
      • Ancient1
        How to Test : Bad Backlight Driver OR Faulty_Strip
        by Ancient1
        Hi

        Its a "dumb" question , and an answer probably available somewhere ..

        Assume no Backlight Tester or exposed Strips , PSU has V/A Outputs Table.

        This transforms the question to :

        How to Test the Driver in uncovered TV ?

        Thx
        01-01-2023, 05:05 AM
      • Loading...
      • No more items.
      Working...