Baird 40" vertical lines on left side screen?

Collapse
X
 
  • Time
  • Show
Clear All
new posts
  • PhaseCoder
    Senior Member
    • Nov 2013
    • 62
    • Uk

    #1

    Baird 40" vertical lines on left side screen?

    Here I have aquired this baird at £10 and has lines on the left side no matter what.

    Can anyone relate or tell me a fix?

    see pic

    thanks in advance
    Attached Files
  • ReeceyBurger123
    Never Give Up !
    • May 2014
    • 7325
    • Britain

    #2
    Re: Baird 40" vertical lines on left side screen?

    Bad panel not fixable sorry
    Please Do Not PM My Page Asking For Help Badcaps Is The Place For Advise, Page Linked For Business Reasons Only. Anyone Doing So Will Be Banned Instantly !

    https://www.facebook.com/Telford-Tel...7894576335359/

    Comment

    Related Topics

    Collapse

    • Stanley1843
      Screen Display Vertical Multicolor Lines
      by Stanley1843
      Hello, I have a screen in where sometimes when I open it pop-up vertical multicolor lines (I would say the most of them are green). If I tun off and turn on the screen the lines dissapear or if I leave open the screen after approximately five minutes the lines gone. I measured the below voltages on the main PCB and on the T-CON board and the voltages are the same when it doesn’t display the vertical lines and when it displays the vertical lines. Also, I cleaned all the connectors very good with IPA. I moved back and forth the connectors and the COF tabs but the vertical lines didn't displayed...
      06-29-2024, 11:54 AM
    • x_orange90_x
      Vizio V585-J01 dancing lines and image doubling
      by x_orange90_x
      I got this tv yesterday and it shows a screen full of colored vertical bars and horizontal lines that move, change, and dance around. When the set is powered on there is a slight buzz from the tcon. I removed one ribbon at a time and this was the result:

      Right side connected, left side disconnected = half image on right (somewhat distorted, see photo attached) white screen on left. NO buzzing from TCON

      Left side connected, right side disconnected = right side black, left side white with distorted horizontal lines near top of screen. Buzzing from TCON

      I swapped...
      06-12-2024, 07:57 AM
    • shlomim412
      samsung ua55es6800 - no image
      by shlomim412
      hi
      having problem with samsung ua55es6800

      tv had backlight on, sound working - responds to the remote control but no image.

      check tcon board - had 12v in but no other voltages present.
      when disconnected left ribbon cable - got back voltages and half image with lines and distorsion

      when leaving only left side connected - again no voltages and no image.

      put a tape on all (cd?! lines) on the left ribbon cable and got complete but distorted image (horizontal lines).

      kept trying to block less pins on the left ribbon cable...
      05-15-2024, 05:00 AM
    • gpo23
      Sony KDL-40V3000 - Vertical lines
      by gpo23
      Hello,

      i order a t-con because i had bad colors on my SONY KDL-40V3000 :




      With the new t-con the color are good but there are vertical lines on all the screen :




      I've tried the old t-con and it returned to the initial issue (bad colors but no vertical lines)

      Is there a way to fix the vertical lines on the new t-con ?

      Thank you for your help

      gpo23...
      10-04-2023, 09:11 AM
    • Helikvar
      Hisense 58A6KV
      by Helikvar
      No picture ,tv appears to turn on and off using remote as standby led goes from red to nothing when on and red again when off
      . Backlights also light up when tv is powered on.
      Removing panel ribbon cable from left side screen still dark.
      Removing panel ribbon cable from right side the right panel is white and left panel is dark but within a few seconds the left panel has a large green vertical bar and beside it many thin red lines.This whole screen dims down to dark within a few seconds and the right side slowly turns white again.
      . Tcon gets 12 volt
      . Tried taping...
      02-21-2025, 03:52 PM
    • Loading...
    • No more items.
    Working...