I'm working on a Seiki SE50FY10 that has sound and no picture. Power supply is fine but isn't receiving the signal to activate the LED backlights. I have narrowed it down to the main board. From what I can tell, the EEPROM (U2) on the main board would be the first fault in this. The part is an 8 leg IC that is a WINBOND 25q16cvsig. Does anyone agree with me? And, does anyone have a cross reference for it? I want a higher quality IC that is compatible. Thanks!
-
You Can't Succeed Until You're Willing to Fail -
Re: Seiki SE50FY10 sound no picture
shopjimmy also sells the direct replacement for this. I want to order through DigiKeyAttached FilesYou Can't Succeed Until You're Willing to Fail -
-
Re: Seiki SE50FY10 sound no picture
Are you aware that the W25Q16CVSIG IC needs to be programmed? AFAIK, Digikey only sell blank ICs.
In any case, before ordering a part on suspicion, I would at least measure the supply voltages on the main PCB. Check the voltages at the LDO regulators and the coils.Comment
-
Hi, I have a Samsung UE50TU with:
- sound and backlight, but no picture
- when it arrived, it had a picture for a few seconds
- it keeps rebooting
- without ribbon cable between the two panel boards, it does not reboot but I have no picture
- without cable between mainboard and lcd panel, it does not reboot (but obviously i have no picture)
- when i try a tape fix, its keeps rebooting, unless I tape off pin 1 (the innermost pin). In that case it does not reboot but I have no picture.
- without cable between mainboard and lcd panel and with a jumpered... -
I have a 60 inch Samsung UN60EH6000F flatscreen TV. The screen went black a few months ago Sound is good, backlight is good, no menu. I replaced the TCon board with a used board purchased from Ebay. It worked fine for a 3-4 months, then the screen started ‘fading' back. Once again, sound is good, backlight is good, no menu. However, this time the picture looks fine for about 10-15 minutes, then fades back. If I power cycle the TV, the display reappears, for another 10-15 minutes, then fades black again. Repeatable ever time.
I ordered a supposedly ‘new' Tcon board this time, and... -
Hello everyone,
Ive got a UE60KU6079 on the workbench that is giving me some headaches trying to troubleshoot.
The previous owner stated that there had been white dots on the screen which from the description sounded like some lenses fell of the backlight LEDs.
He had opened the TV from the back, trying to get to the backlight, supposedly gave up, reassebled everything and gave the TV to me.
I expected the worst like ripped COF cables or a cracked panel but could not find anything like that yet.
Anyway I still fully expect that there has been something seriously damaged... -
Hi all
I was just given a Samsung TV with the issue. I read various threads and videos and attempted the ribbon tape method to gain an image, but no luck.
Symptom:
No picture no sound.
When I plug in the power cord, Backlight LED turns on for a half second and then turns off. The red LED next to the power button located center bottom flashes 2 or 3 times. When the power button is pressed after, it does the same thing.
No sound at all.
What I tried:
1. I tried unplugging the left or right ribbon... -
so i took out one of my spare gigabyte ep35-ds3r mobos from storage for use to do some cpu, ram and video card testing of stuff i bought from ebay and got for free from momaka. he bought 50 e8400 cpus for cheap from ebay some years ago and i decided to help him relieve him of some of his supply since he had waaaay too many!!
what did we say about hoarding too much stuff and depriving others of them?! *cough* socialism *cough* lol! 
i had to blow some dust off the board and heatsinks with the datavac as i didnt clean it up before putting it in storage. after finishing...
Comment