My tv turns on I get blue light but no pict or splash screen I hear static or fuzzy noise from speakers could this be a bulb or lamp issueand where is it on this set thanks
-
Hi all, I have a polaroid p49fn0038k, I originally thought the problem was just a straight forward backlight replacement, however this isn't the case..
When I power it up, the backlights flash on for a split second, I've tested the backlight strips and all are fine, I can see the polaroid symbol on the screen using a torch light....
Any help would be greatly appreciated
Thanks in advance11-10-2022, 10:30 AM -
polaroid TQLHD24PR004 no power
hi, my tv no longer starts like dead, no standby led
motherboard : MS36639-ZC01-01
panel : V236BJ1-P01
flash spi: GD25Q64
need usb firmware or to reprogramβ -
Good afternoon,
I have a Polaroid P43D300.
It shipped with WiFi and Bluetooth.
Two weeks ago, I ran through the first time installation.
This did a full reset and went through the first time setup.
Once complete, I went to settings > sound.
selected Audio Link, changed setting from disabled to enabled, pressed green button on remote and the tv does a search (discovery) for Bluetooth devices.
search completes and doesn't find any devices.
I have tried everything I can think of.
Can someone provide... -
Hello,
I am looking for the Dump Firmware of this model.
Mark: Polaroid
Model: TQL48R4PR003
Main board chassis: CV9203H-A42
LCD Screen / Panel: 15y_s48ff11mb7s4lv0.1
More information: W25Q32
thank you for your reply -
Hello,
i have an issue with my polaroid TV Model : tql39r4pr002
the standby led is red , and when i turn on the TV it shows the polaroid logo and turns off, also the standby led switches to blue the back to red .
capacitors are apparently ok, i have 320V in the smoothing primary capacitor, and 13V in the diodes in the secondary.
i don't understand why the mainboard switches to this mode and don't turn on.
don't find any service manual for this model ,or the main board schematic. cv9203h-a42
thank you for your help....