LG 50PS60 No picture no sound

Collapse
X
 
  • Time
  • Show
Clear All
new posts
  • rogue409
    New Member
    • Oct 2014
    • 7
    • USA

    #1

    LG 50PS60 No picture no sound

    My LG 50PS60 just died with no picture, no sound. Here's what I've done so far to troubleshoot (following Tom66's guide).

    1. Disconnect Ysus: Still no picture, with partially working sound. It seems to about 1/3rd of the music.
    2. Disconnect Zsus: Red/pink tinted picture with sparklies and fully functioning sound.
    3. Checked voltages at the PSU
    5v: 5.05V
    VA: Spec 65, Actual 64.4V
    VS: Spec 194, Actual 194.2

    Seems like a problem with Zsus, what do you all think?

    I have a pile of pics that I can post, but I'm not sure which ones will be most helpful. If I can figure out which board is causing the problem, I'll probably replace it instead of troubleshooting further. My soldering skills are non-existent.
  • tom66
    EVs Rule
    • Apr 2011
    • 32560
    • UK

    #2
    Re: LG 50PS60 No picture no sound

    Z-sustain is a very common fault on this model.
    The fix is reasonably complicated, there are repair services available online. Or you can replace the whole board.
    Please do not PM me with questions! Questions via PM will not be answered. Post on the forums instead!
    For service manual, schematic, boardview (board view), datasheet, cad - use our search.

    Comment

    • rogue409
      New Member
      • Oct 2014
      • 7
      • USA

      #3
      Re: LG 50PS60 No picture no sound

      Originally posted by tom66
      Z-sustain is a very common fault on this model.
      The fix is reasonably complicated, there are repair services available online. Or you can replace the whole board.
      Thanks for the confirmation! I'll update when I replace the Z-sustain.

      Comment

      • rogue409
        New Member
        • Oct 2014
        • 7
        • USA

        #4
        Re: LG 50PS60 No picture no sound

        Replaced the Z-sus board. Powered it up....and got a little puff of smoke from the new Z-sus. Major bummer.

        Comment

        • tom66
          EVs Rule
          • Apr 2011
          • 32560
          • UK

          #5
          Re: LG 50PS60 No picture no sound

          Sounds like your new zsus was anything but. Where did you buy it from? Did you have all screws installed? Was the rubber pad in the bottom installed too?
          Please do not PM me with questions! Questions via PM will not be answered. Post on the forums instead!
          For service manual, schematic, boardview (board view), datasheet, cad - use our search.

          Comment

          • rogue409
            New Member
            • Oct 2014
            • 7
            • USA

            #6
            Re: LG 50PS60 No picture no sound

            Originally posted by tom66
            Sounds like your new zsus was anything but. Where did you buy it from? Did you have all screws installed? Was the rubber pad in the bottom installed too?
            I bought it from ebay. I installed about half of the screws -- I'm guessing that's not good.

            With the "new" broken board in, the tv powers up but has little sparklies.
            Last edited by rogue409; 10-21-2014, 06:53 AM.

            Comment

            • Alastair E
              Chief Womble
              • Mar 2013
              • 1963
              • U.K.

              #7
              Re: LG 50PS60 No picture no sound

              Unfortunately--Looks like your Z-SUS died because all the earthing screws were not in place.....

              The screws and the pads on the board earth the tracks to the chassis. If some are not present can have odd effects--or destruction of the boards
              TELEFIX

              How PLASMA SCREENS WORK, X-SUS and Y-SUS what they do--
              http://www.irf.com/technical-info/appnotes/an-1088.pdf
              PLEASE DO NOT EMAIL ME PRIVATELY FOR REPAIR ADVICE. QUESTIONS BELONG ON THE FORUM!

              Comment

              • rogue409
                New Member
                • Oct 2014
                • 7
                • USA

                #8
                Re: LG 50PS60 No picture no sound

                Originally posted by Alastair E
                Unfortunately--Looks like your Z-SUS died because all the earthing screws were not in place.....

                The screws and the pads on the board earth the tracks to the chassis. If some are not present can have odd effects--or destruction of the boards
                ....as I found out last night.

                Comment

                • rogue409
                  New Member
                  • Oct 2014
                  • 7
                  • USA

                  #9
                  Re: LG 50PS60 No picture no sound

                  Replaced Z-sus and everything works! Thanks everyone!

                  Comment

                  • tom66
                    EVs Rule
                    • Apr 2011
                    • 32560
                    • UK

                    #10
                    Re: LG 50PS60 No picture no sound

                    Glad to hear, these are pretty good TVs.
                    Please do not PM me with questions! Questions via PM will not be answered. Post on the forums instead!
                    For service manual, schematic, boardview (board view), datasheet, cad - use our search.

                    Comment

                    Related Topics

                    Collapse

                    • TR103
                      Samsung TV model UE50TU: rebooting, backlight, sound, but no picture
                      by TR103
                      Hi, I have a Samsung UE50TU with:
                      - sound and backlight, but no picture
                      - when it arrived, it had a picture for a few seconds
                      - it keeps rebooting
                      - without ribbon cable between the two panel boards, it does not reboot but I have no picture
                      - without cable between mainboard and lcd panel, it does not reboot (but obviously i have no picture)
                      - when i try a tape fix, its keeps rebooting, unless I tape off pin 1 (the innermost pin). In that case it does not reboot but I have no picture.

                      - without cable between mainboard and lcd panel and with a jumpered...
                      01-22-2025, 04:12 PM
                    • Mgiffune
                      Samsung UN60EH6000F Black Screen, Backlight and Sound Good. Power Cycle Returns Picture
                      by Mgiffune
                      I have a 60 inch Samsung UN60EH6000F flatscreen TV. The screen went black a few months ago Sound is good, backlight is good, no menu. I replaced the TCon board with a used board purchased from Ebay. It worked fine for a 3-4 months, then the screen started ‘fading' back. Once again, sound is good, backlight is good, no menu. However, this time the picture looks fine for about 10-15 minutes, then fades back. If I power cycle the TV, the display reappears, for another 10-15 minutes, then fades black again. Repeatable ever time.

                      I ordered a supposedly ‘new' Tcon board this time, and
                      ...
                      06-09-2024, 10:28 AM
                    • Ierwin
                      Samsung UE60KU6079 backlight okay mainboard responsive, no picture, no sound
                      by Ierwin
                      Hello everyone,
                      Ive got a UE60KU6079 on the workbench that is giving me some headaches trying to troubleshoot.
                      The previous owner stated that there had been white dots on the screen which from the description sounded like some lenses fell of the backlight LEDs.
                      He had opened the TV from the back, trying to get to the backlight, supposedly gave up, reassebled everything and gave the TV to me.
                      I expected the worst like ripped COF cables or a cracked panel but could not find anything like that yet.
                      Anyway I still fully expect that there has been something seriously damaged...
                      05-13-2025, 03:31 PM
                    • jchang
                      Samsung UN70NU6900F no picture and no sound
                      by jchang
                      Hi all

                      I was just given a Samsung TV with the issue. I read various threads and videos and attempted the ribbon tape method to gain an image, but no luck.



                      Symptom:
                      No picture no sound.
                      When I plug in the power cord, Backlight LED turns on for a half second and then turns off. The red LED next to the power button located center bottom flashes 2 or 3 times. When the power button is pressed after, it does the same thing.
                      No sound at all.



                      What I tried:
                      1. I tried unplugging the left or right ribbon...
                      01-09-2023, 06:28 PM
                    • ChaosLegionnaire
                      what i went through dealing with my mobo with dead onboard sound!
                      by ChaosLegionnaire
                      so i took out one of my spare gigabyte ep35-ds3r mobos from storage for use to do some cpu, ram and video card testing of stuff i bought from ebay and got for free from momaka. he bought 50 e8400 cpus for cheap from ebay some years ago and i decided to help him relieve him of some of his supply since he had waaaay too many!! what did we say about hoarding too much stuff and depriving others of them?! *cough* socialism *cough* lol!

                      i had to blow some dust off the board and heatsinks with the datavac as i didnt clean it up before putting it in storage. after finishing...
                      09-13-2022, 09:02 AM
                    • Loading...
                    • No more items.
                    Working...