I'm not sure if the button board is serviceable since it's not mounted with screws...it looks like they laid the board down on two plastic pegs and then melted the pegs down over the board so if I removed it I wouldn't have a way to put it back..
OK, the IR1 Receiver which has 3 pins, check and see if any of them has DC Voltages, also check those TP test points to see if they show any DC voltages also.
I still need to clean the contacts and buy new AAA batteries but haven't had time to do either yet. I've been slammed with homework I might be able to do it tomorrow but if I don't I will update on Sunday evening. Thank you for helping out!
Comment