LG 65LW6500

Collapse
X
Collapse
 
  • Page of 1
  • Time
  • Show
Clear All
new posts
Previous template Next
  • JohnML1975
    Member
    • Jul 2025
    • 36
    • Australia
    #1

    LG 65LW6500

    Hello all

    thought I would start a thread on this model

    connected to power
    cannot see a standby light
    when i press the power button on the TV a standby light does appear and it is white
    there is no picture and no sound
    i looked for picture with a torch and could not see one
    i pressed the power button again and the standby light went out

    shall start to remove rear cover and look what i can see

    thank you
    Tags: None
    • JohnML1975
      Member
      • Jul 2025
      • 36
      • Australia
      #2
      Here are some photos
      I cannot see anything visually at the moment
      Tried to disconnect the mainboard but TV just turned off
      I had hoped the backlights might come on
      Anyway I am going to focus on the LEDs

        Comment

        • JohnML1975
          Member
          • Jul 2025
          • 36
          • Australia
          #3
          5 Photos

            Comment

            • Diah
              Badcaps Legend
              • Feb 2013
              • 6399
              • Germany
              #4
              hello,
              such grand papa TV i never had under hand... however we need voltage reading from the socket between PSU and MB at PSU socket side..

                Comment

                • lotas
                  Badcaps Legend
                  • Jan 2016
                  • 4660
                  • Russia
                  #5
                  The main problem with this LW series, this chassis (LD12C) is the failure of the main processor, a reball is needed, for diagnostics, blow a hair dryer without fanaticism on the processor and the TV should start.

                    Comment

                    Previous template Next

                    Related Topics

                    Collapse
                    • slimsoul
                      Samsung TV`s UE32J5500AK and UE48H6400AK Red Standby Light - No Picture/Sound
                      by slimsoul
                      Hi, I'm new here and looking for some advice on how to diagnose an issue i have with 2 samsung TVs.

                      I have a UE32J5500AK and a UE48H6400AK both with the same issue of red light but nothing happening on the screen, the red light responds to remote or button press by flashing once but stays red. I have searched forums but most turn up a blinking red light.

                      I have tried replaceing the power board on the UE32J5500AK last year but this resulted in the same outcome.
                      The UE48H6400AK recently developed some small bright areas on the screen, then last week would not power...
                      03-12-2024, 03:55 AM
                    • PNI E.
                      tcl u65x9006 back light on but no picture sounf ok after 40 50 secs
                      by PNI E.
                      hi guys, i need your help again...i have tcl u65x9006. while i was watching it become darker like when a movie ends, little by little the image disappear. now if i turn on i have back light on, after like 1 min i have also sound but no picuture. the back light is on i take off one at time the ldvs but nothing change always no picture. i tried to cover with a piece of paper the pin of ldvs i cover like 7 8 pins but nothing worked. the tv stay with no picture. there is a tcon board.i checked the voltage there on the fuse i have 11,8 volts. there is caps in shorts on the exit of the tcon i have...
                      02-20-2025, 08:36 AM
                    • AleMonti
                      LG 55EG910V - no power and no standby light
                      by AleMonti
                      Hi everyone,
                      I'm trying to troubleshoot and repair this old LG OLED curved TV, model 55EG910V.
                      I did some basic troubleshooting and reviewed most related posts here, but I wasn't able to isolate the issue.

                      The TV shut itself off during playback and never came back to life - the standby light remains off. My dad claims that it has happened a few times in the past but the issue resolved itself after some time. Not this one.

                      After checking the basics I did the following:
                      • I measured all voltages and as expected the only active supply is the 3.5V standby. It
                      ...
                      11-04-2024, 05:02 PM
                    • koby058
                      vostro comes up with back light but no picture
                      by koby058
                      Hi people!!
                      The owner said it showed bad picture once in a while (attached)
                      I see that there is back light but no picture.
                      I want to ask if it is possible to disable the NVIDIA GPU and use the intel one?

                      Also attached schematic and BDV

                      LINK to schematic & boardview - https://www.badcaps.net/forum/troubl...ll-vostro-5590...
                      07-13-2025, 01:03 PM
                    • jasonbay13
                      Philips 37HFL5682L/F7 no standby light, incomplete service manual?
                      by jasonbay13
                      picked up a tv and when the power is plugged, the standby light flashes real quick then goes off. of 3.3, 12, 24v is all there but i couldnt find any 5v on the back-end board. ON/OFF is low, which it seems is what turns on the backlight so i removed the wire at the back-end board and put a 10k resistor to the 3.3v, which when plugged in brings on the backlight for a split second and also a blue light "LED1" on the inverter board, which goes off after a short time.
                      am i missing something to bring on the backlight or is the inverter/ccfl gone bad? would that cause the inverter board...
                      http://cerealbargain.duckdns.org
                      12-01-2023, 09:55 PM
                    • Loading...
                    • No more items.
                    Working...