Hello everyone.
I am pretty new in TVs and Receivers but I am a computer engineer.
I recently got the non working Pioneer 50" plasma PDP-506PU with the receiver PDP-R06U.
I connected them together and hoocked the HDMI port. The TV wasn't show anything. The receiver was reacting on remote. It was switching between standby and On.
I opened the back panel and got very dusty boards inside. I did vacuum cleaning and, just to make sure it is working before I put everything back, turned it on.
Of course the Trap Switch fired and now my receiver has all LED powered: On, standby and timer. as far as I understand the trap state has been stored somewhere on the Flash and needs to be reset before continuing.
I read many manuals and service manuals they all says to reset it you need to enter factory mode: use your remote control and to "Display", wait for 3-7 seconds, then < ^ < > and Power.
It does not work. I have tried to use remote control with the receiver and tv. they do not show any reaction. I have tried to connect it with COM port (RS-232) but service manual says that by default the SR port is working while RS-232 is down. Manual says that I can switch it in factory mode somwhere in menu but I cannot do that because my receiver is locked.
Who knows anything about this reciever and how to fix this stuff.
Any comment will be highly appreciated.
Thanks everyone. Alex
I am pretty new in TVs and Receivers but I am a computer engineer.
I recently got the non working Pioneer 50" plasma PDP-506PU with the receiver PDP-R06U.
I connected them together and hoocked the HDMI port. The TV wasn't show anything. The receiver was reacting on remote. It was switching between standby and On.
I opened the back panel and got very dusty boards inside. I did vacuum cleaning and, just to make sure it is working before I put everything back, turned it on.
Of course the Trap Switch fired and now my receiver has all LED powered: On, standby and timer. as far as I understand the trap state has been stored somewhere on the Flash and needs to be reset before continuing.
I read many manuals and service manuals they all says to reset it you need to enter factory mode: use your remote control and to "Display", wait for 3-7 seconds, then < ^ < > and Power.
It does not work. I have tried to use remote control with the receiver and tv. they do not show any reaction. I have tried to connect it with COM port (RS-232) but service manual says that by default the SR port is working while RS-232 is down. Manual says that I can switch it in factory mode somwhere in menu but I cannot do that because my receiver is locked.
Who knows anything about this reciever and how to fix this stuff.
Any comment will be highly appreciated.
Thanks everyone. Alex
Comment