I had this tv set, stuck at the 'SMARTTV' screen with coloured logo. Impossible to find the original Smart Tech firmware, so i searched in kazmielec.tech some firmware compatible with the tv-set hardware (CV338H-T42 card and Y400HJ6.PE1 screen). The firmware i tried was wrong and it bricked the TV, just showing a black screen and not entering stand by anymore. I supposed it needed special hardware to reflash the NAND, but i was wrong, it just needed a working compatible firmware. Still in the kazmielek page i tried ' CV338H-T42_1920x1080_Telefunken TF-LED43S81T2' and it finally worked. I wrote it on a usb stick, i pressed the power button on tv and i inserted the plug in power outlet, and the standby led started to flash red and green. After some time the procedure stopped, and the TV finally started to show images again, reversed but finally working. I fixed the image issues in service menu (entering tv menu and 1147 with remote). The TV remote is completely compatible with the Telefunken firmware, only difference is the HOME and ASPECT key reversed.
-
-
https://mega.nz/file/5FBz2TzQ#VMEFOm...O9ElyQOV68GZBY
here is the firmware, of course it must be unzipped, in a FAT32 formatted usb stick.
-
Hey everyone,
I’ve got a MacBook Air A2179 that got some water damage through the keyboard. Now it powers on, shows the Apple logo, but just stays stuck there — no startup chime, no keyboard backlight, and no progress bar under the Apple logo.
When I try to boot into Internet Recovery (Option + Command + R), the mouse cursor is extremely slow and laggy — like when I lift my finger off the trackpad, the cursor keeps drifting slowly for a second or two.
I opened it up and found some corrosion around the LED driver IC area on the logic board. I cleaned... -
I just got this tv today and it's getting stuck on the wallpaper. When I first power it on it goes to the V logo, then a black screen for about 15 seconds, then a Chromecast error for just a few seconds, and then finally to a wallpaper. It stays frozen on this wallpaper and does not respond to anything on the remote besides power on/off. Likewise the buttons on the tv do nothing either (besides power). I did the "reset" by holding the volume down and input buttons together for 10 seconds. It showed a message at the top of the screen saying it was Wiping Data and would restart soon. After... -
Philips 8200 series 65PUS8204/12 stuck at Philips Logo, it does not reboot it just stays on the logo.
It does power up when pressing the power button.
I already try the power button while plugin the plug with no result.
Also put the latest firmware autorun-TPM191E_R.001.004.100.000.upg on a MBR/FAT32 USB stick at USB port2 with no result either.
Could this be an PSU or eMMC issue ? -
Hi i need this bios it stuck in dell logo can help me
MB: starlord13 b 152641
SN: 5F50ZB2... -
Laptop MACHENIKE model L15A RN
Board model V150RNEMB-OD
Stuck on logo no boot, suspect Clean ME
Please help me!...
Comment