Hi all, new here but I have a 42" LG plasma that I got for nothing, it made a loud pop and he picture went on it. I did some troubleshooting but nothing too crazy because I have limited electronics repair experience. The y-sustain had a blown fuse and cold heat sinks after leaving it on for 20 minutes. So, I replaced the y sustain and buffer but it is still the same. The x sustain was replaced in 2010 and the tv hasn't been used since it broke in 2011 so I don't think that's the issue. All fuses are still good, I checked those, but the board on the center back has a few green leds and one red one, d1303. Sorry for the long post but any ideas? Could the y sustain I got be busted too?
Cliff notes: replaced x sustain, y sustain, y buffer and still no picture.
Cliff notes: replaced x sustain, y sustain, y buffer and still no picture.
Comment