My Philips Plasma 50PF9631D/10 had a bad Y-sus which I replaced.
After checking all voltages the only problem is that the Vs voltage cannot be set lower than 206 V with the pot.
On the panel label is indicated 198V. I changed numerous suspicious caps already with no effect.
The screen image is perfect and everything works, but won't close the cover until the voltage is correct again.
It's a Samsung PSU LJ44-00125a.
Does anybody has experience with this problem?
After checking all voltages the only problem is that the Vs voltage cannot be set lower than 206 V with the pot.
On the panel label is indicated 198V. I changed numerous suspicious caps already with no effect.
The screen image is perfect and everything works, but won't close the cover until the voltage is correct again.
It's a Samsung PSU LJ44-00125a.
Does anybody has experience with this problem?