Make sure not to confuse a single "1" on meter with 0.0 ohms.
Please do not PM me with questions! Questions via PM will not be answered. Post on the forums instead!
For service manual, schematic, boardview (board view), datasheet, cad - use our search.
Please do not PM me with questions! Questions via PM will not be answered. Post on the forums instead!
For service manual, schematic, boardview (board view), datasheet, cad - use our search.
Hi yes the light comes on when cycling about 6 times.
Then goes out
If I unhook tcon from psu the tv starts up but no picture.
Or if I unhook y main. It starts up
I'm getting so frustrated with this tv
Any help would be appreciated
Please do not PM me with questions! Questions via PM will not be answered. Post on the forums instead!
For service manual, schematic, boardview (board view), datasheet, cad - use our search.
Please do not PM me with questions! Questions via PM will not be answered. Post on the forums instead!
For service manual, schematic, boardview (board view), datasheet, cad - use our search.
Means f*** all... you could have got a bad board and that has happened to me MANY times. Sellers just don't test their boards.
Please do not PM me with questions! Questions via PM will not be answered. Post on the forums instead!
For service manual, schematic, boardview (board view), datasheet, cad - use our search.
Check ohms between Vs and GND, and check all transistors/diodes (mounted on heatsinks.)
Please do not PM me with questions! Questions via PM will not be answered. Post on the forums instead!
For service manual, schematic, boardview (board view), datasheet, cad - use our search.
I am having the same problem, if I disconnect the y board the tv chimes but don't get no picture, i have changed power board, t con board and y board, the only possible other thighs it could be is the y buffer board, how can I test this to see if that is the problem, any help and ideas welcome thanx
I've fitted new y buffer board and still no luck, I have come to the conclusion that it must be that z board, I have disconnected both cables from the y board and the tv gets the chimes but still no pic does that point to the z board?
Comment