Hi Guys,
Can anybody comment on were they think the fault is with this plasma from the attached photo?
Thanks.
Can anybody comment on were they think the fault is with this plasma from the attached photo?
Thanks.
Attached Files
-
-
Re: LG Plasma RZ 60-PY10
Most likely cracked solder joints on the COF resistors.
The COF are at top and bottom of panel, and run the length of the panel.
There may be burn in where the parts of the image did not light properly.Please do not PM me with questions! Questions via PM will not be answered. Post on the forums instead!
For service manual, schematic, boardview (board view), datasheet, cad - use our search. -
Re: LG Plasma RZ 60-PY10
Thanks Tom.
Should I only be looking at the cof chips at the top of the panel as the lines are at the top of the screen? Is it possible to resolder them?Last edited by blib; 11-11-2013, 01:09 PM.Comment
-
Re: LG Plasma RZ 60-PY10
Yes, and yes.Please do not PM me with questions! Questions via PM will not be answered. Post on the forums instead!
For service manual, schematic, boardview (board view), datasheet, cad - use our search.Comment
Comment