Announcement

Collapse
No announcement yet.

22me402v led tv strobe light effect

Collapse
X
 
  • Filter
  • Time
  • Show
Clear All
new posts

    #41
    Re: 22me402v led tv strobe light effect

    Would bl_sw and bl_adj be the equivalent?
    Did I leave the soldering iron on?

    Comment


      #42
      Re: 22me402v led tv strobe light effect

      Considering this hai 7209pc stellar reputation for failure is there a way to inject the voltages directly to the led strip and bypassing the constant current circuit? How about pin shorting on the ic? I have a feeling something is wrong with the ic
      Did I leave the soldering iron on?

      Comment


        #43
        Re: 22me402v led tv strobe light effect

        does anyone have a datasheet on the HAI 7209PC led controller ic?
        Did I leave the soldering iron on?

        Comment


          #44
          Re: 22me402v led tv strobe light effect

          Perhaps this could provide little more info on that IC https://www.badcaps.net/forum/showthread.php?p=359967

          Comment


            #45
            Re: 22me402v led tv strobe light effect

            Read it last night. Whats is going in there. Are they injecting raw voltage to the leds via stand alone inverter?
            Did I leave the soldering iron on?

            Comment


              #46
              Re: 22me402v led tv strobe light effect

              Trying to get thus tv figured out still. I have consistent 45vdc going to the led strip center pin. The four outer pins are used for current sensing?
              Did I leave the soldering iron on?

              Comment


                #47
                Re: 22me402v led tv strobe light effect

                well since this tv is so cheaply made and personally I really don't care I went a head and started doing some hack job mods. I took the current balancing pins which is essentially ground for the LED's and disconnected from the circuit and grounded them to the chassis. The LED still power up but I still have flickering. So now I'm trying to find a good 45 volt source of the power supply to apply the positive for the LED's direct anyone have any ideas?
                Did I leave the soldering iron on?

                Comment


                  #48
                  Re: 22me402v led tv strobe light effect

                  and my hack job appeared to work! Full brightness beautiful picture anyone wants to know how it was done I took a .33ohm resistor and put it across two pins. 10 and 11 off the hai 7209pc ic disabling the current sensing on the ic. Also removed a smd capacitor and resistor from the circuit but its not nessecary.

                  Heres the pic


                  http://i845.photobucket.com/albums/a...psb8978d1d.jpg
                  Last edited by freakaftr8; 11-04-2013, 01:58 AM.
                  Did I leave the soldering iron on?

                  Comment


                    #49
                    Re: 22me402v led tv strobe light effect

                    Better pic


                    Did I leave the soldering iron on?

                    Comment


                      #50
                      Re: 22me402v led tv strobe light effect

                      Is it normal for the led strip ti get nice and toasty under full illuminaton?
                      Did I leave the soldering iron on?

                      Comment

                      Working...
                      X