Philips Plasma 50PFP5332D/37 Power but no picture

Collapse
X
 
  • Time
  • Show
Clear All
new posts
  • Frost_Trunks
    New Member
    • Jul 2013
    • 3
    • USA

    #1

    Philips Plasma 50PFP5332D/37 Power but no picture

    Hello everyone.

    I have been trying to troubleshoot this TV for a while now, but I have been unsuccessful. A few months back, I was playing Nintendo Wii with my fiance. We shut the TV off after playing, but when we turned it back on later no picture would show. The blue power light comes on and I here a "click" noise like it normally does, but no picture shows.

    I took the back off and checked all the fuses and all of them have through voltage. There was one capacitor on the center board that was swollen (top left of board). I replaced it with one that matched the UF and voltage but still no picture. Hoping somebody has some ideas. I haven't had the television for more than 4-5 years.

    Here are some photos of the inside of the back of the TV.

    Philips Plasma 50PFP5332D/37

    https://dl.dropboxusercontent.com/u/...8/IMG_3708.JPG
    https://dl.dropboxusercontent.com/u/...8/IMG_3709.JPG
    https://dl.dropboxusercontent.com/u/...8/IMG_3710.JPG
    https://dl.dropboxusercontent.com/u/...8/IMG_3711.JPG
    https://dl.dropboxusercontent.com/u/...8/IMG_3712.JPG

    Thanks in advance!!

    John
  • capkid
    Badcaps Legend
    • Oct 2010
    • 1339
    • United States

    #2
    Re: Philips Plasma 50PFP5332D/37 Power but no picture

    Do you have sound?
    LG Plasma Mal-Discharge Correction Service

    Comment

    • topfli8979
      Badcaps Veteran
      • Oct 2012
      • 311
      • USA

      #3
      Re: Philips Plasma 50PFP5332D/37 Power but no picture

      Are your vs/va voltages on ps correct?

      Comment

      • Frost_Trunks
        New Member
        • Jul 2013
        • 3
        • USA

        #4
        Re: Philips Plasma 50PFP5332D/37 Power but no picture

        Not sure on the sound, I will have to plug in the PS3 and boot it up. It's kind of hard to tell since I cannot select the correct input. What should the voltages be on the PS?

        Comment

        • tom66
          EVs Rule
          • Apr 2011
          • 32560
          • UK

          #5
          Re: Philips Plasma 50PFP5332D/37 Power but no picture

          Vs and Va exact voltages are written on the plasma panel, but should be around 200V and 60V.
          Please do not PM me with questions! Questions via PM will not be answered. Post on the forums instead!
          For service manual, schematic, boardview (board view), datasheet, cad - use our search.

          Comment

          • reed
            New Member
            • Apr 2014
            • 7
            • United States

            #6
            Re: Philips Plasma 50PFP5332D/37 Power but no picture

            Hello Everyone,
            I am a newbie this is my first post and this thread seems to be the closest to the problem I am having with my Philips Plasma 50PFP5332D/37.
            Power on light comes on blue, you hear the click and then red light flashes 6 times.
            I found a problem fuse on power supply board (see pic with red arrow showing fuse) and replaced it with new one. Powered on and blew fuse right away with same red flashing light. Now I am stumped Does anyone have any advice on how to troubleshoot or best guess problem from experience? Any help greatly appreciated
            Attached Files

            if you find these attachements useful please consider making a small donation to the site

            Comment

            Related Topics

            Collapse

            • PNI E.
              tcl u65x9006 back light on but no picture sounf ok after 40 50 secs
              by PNI E.
              hi guys, i need your help again...i have tcl u65x9006. while i was watching it become darker like when a movie ends, little by little the image disappear. now if i turn on i have back light on, after like 1 min i have also sound but no picuture. the back light is on i take off one at time the ldvs but nothing change always no picture. i tried to cover with a piece of paper the pin of ldvs i cover like 7 8 pins but nothing worked. the tv stay with no picture. there is a tcon board.i checked the voltage there on the fuse i have 11,8 volts. there is caps in shorts on the exit of the tcon i have...
              02-20-2025, 08:36 AM
            • Patrick501
              Philips 55PUS6704 no picture, backlight ok
              by Patrick501
              Hello,
              I'd like to repair a Philips 55PUS6704.
              It turns on and you can see the backlight, hear the sound but no picture.

              When I disconnect one of the T-con cables, half of the screen turns white.
              right cable disconnected= right side white
              left cable disconnected= left side white

              When I tape like 6 or 7 pins of one cable it looks like the picture attached. I already tried another T-con board without success.
              There are no shorts on the the mainbaord and the two lcd panel boards...at leat I couldn't find any.
              Also you can notice one single...
              11-12-2025, 08:46 AM
            • koby058
              vostro comes up with back light but no picture
              by koby058
              Hi people!!
              The owner said it showed bad picture once in a while (attached)
              I see that there is back light but no picture.
              I want to ask if it is possible to disable the NVIDIA GPU and use the intel one?

              Also attached schematic and BDV

              LINK to schematic & boardview - https://www.badcaps.net/forum/troubl...ll-vostro-5590...
              07-13-2025, 01:03 PM
            • madyoyo
              Philips 37pfl560: Yellow picture
              by madyoyo
              HI.

              I have a weird problem with an old Philips 37pfl560 TV i put out of storage: the picture have a noticeable yellow hue, and its not caused by the settings (did a factory reset). I've never seen this before. I will try to get a photo with a real camera, with my phone its hard to see because of automatic white balance, but in real live the whites are really yellow.

              Anyone have an idea of what can cause this? Can CCFL tubes get "warmer" with time? This tv have several analog inputs,so its nice for retrogaming....
              05-30-2025, 10:16 AM
            • KYBOSH
              Trying to Save - LG 60PH6700 60-inch plasma HDTV - Powers ON but no picture
              by KYBOSH
              Saved this beast from the landfill this weekend.
              Manfactured July 2013 in Mexico.

              I love working on plasma TVs.
              Its been a while but I was lucky enough to find 2 this week.

              The TV powers on and stays on but no picture. Havent checked for sound yet.
              No bulging caps although the insides are pretty dusty and the boards are discolored from many years of high heat.
              Will start troubleshooting tonight.

              ...
              10-17-2024, 01:17 PM
            • Loading...
            • No more items.
            Working...