I am looking for a service manual for a Panasonic plasma Th42ph9uk.
Can anyone help please?
Can anyone help please?
-
-
Re: Panasonic #Th42ph9uk plasma.
Try this http://www.tgohome.com/ServiceManual...&Search=Submit
Give it a few minutes to upload if it doesn't yet work.Please do not PM me with questions! Questions via PM will not be answered. Post on the forums instead!
For service manual, schematic, boardview (board view), datasheet, cad - use our search. -
Re: Panasonic #Th42ph9uk plasma.
Try www.tgohome.com/servicemanuals
If not there then try www.elektrotanya.comHave you ever stopped to think and then forget to start thinking again?
As a very wise man once said on this forum: "Of all the things I have lost I miss my mind the most."
Comment
-
I recently got my hands on a 60" Panasonic P60ZT60 plasma tv (european model) that has some strange issues along with an 8 blink code.
It know this tv is getting old but it was once considered one of the best plasmas ever made, and i think it is still holds on to that even by todays standards.
So, long story short. When i first got the tv it had a very bright washed out picture with very raised blacks in all picture modes and i couldn't find the cause in the picture setting menus.
After doing a factory reset this problem was gone and the picture was back to...01-06-2025, 06:02 AM -
Hello, got a ST50 plasma TV for repair. No signs of life, not even blink codes. Opened it up to check the power supply, type MPF6914. Apparent issues from visual detection and measuring for shorts:
Diode type G972s6 - D101 with a short
Mosfet 06N90E - Q301 shorted
Fuse T5AH 250V - F103 blown
Diode D301 shorted
Relay DG1U-17VDC II - RL001 blown
I have not found a circuit diagram. Maybe someone here already dealt with a similar issue? Thanks for tips where else to check 😀... -
I need Schematic A-Board @ Mainboard for Panasonic Plasma TH-P42X28K. Code : TNPH0842. I want to replace 1 MLCC but I don't know values (capacitance & voltage) & codes. Can someone help me? Thank you...11-20-2023, 11:53 PM -
hello,
I hope someone on this forum can assist me.
I have a panasonic TH-42PC77U plasma television.
the lower 1/2 of the screen has become flaky....in and out, then finally goes black and you can only see the top portion.
i have performed the reset to default settings quite a few times. Panasonic recommended..did not believe this would help...it didn't.
I have removed the back panel and looked around for something obvious...burn marks in a board, etc....nothing obvious...
I have read some posts that suggest the problem is related to the boards on the left... -
I have a Panasonic TC-P65V10, Plasma, from 2010. The screen on the unit often dims, then brightens back, and even sometimes completely blacks out, but comes back after a few seconds.
It is not throwing any power led codes. I opened the panel and tightened all the board ground screws. It still does it. It won't do it until after the unit has been on for about 15 minutes.
When it does it, the SS board buzzes a bit, and the P sustain (?) board transformer seems to buzz.
I am not sure if it's worth looking at or if this is a common problem that you may already...
Comment