Hi everyone
Total newbie here I am a carpenter by trade and have a good all round knowledge of the building trades,but i am not very good at fixing tvs.
I have always had an interest in electronics but never the time to pursue it,
friends gave me a lg 50 plasma model number PDP50X30010, that they did not want as it was broken,so to get started on my interest in electronics,this tv seems to be a good place to start.
When I plugged in the tv got sound but no picture,I have read various post on this problem but I am cautious about where to start,if there is anyone that could guide me through the testing procedures,I would be very greatful, bearing in mind I am a total novice.
One thing i have tried is to turn the tv on and leave it on for ten minutes to see if the heat sinks on the y-sus and z-sus boards warm up, the lower one on the y-sus board remain stone cold,the post says that if any of the heats sinks dont get warm then that board has a defect, That is all i have tried so far.
If anyone can help please could you be patient with me.
Thanks
Morph
Total newbie here I am a carpenter by trade and have a good all round knowledge of the building trades,but i am not very good at fixing tvs.
I have always had an interest in electronics but never the time to pursue it,
friends gave me a lg 50 plasma model number PDP50X30010, that they did not want as it was broken,so to get started on my interest in electronics,this tv seems to be a good place to start.
When I plugged in the tv got sound but no picture,I have read various post on this problem but I am cautious about where to start,if there is anyone that could guide me through the testing procedures,I would be very greatful, bearing in mind I am a total novice.
One thing i have tried is to turn the tv on and leave it on for ten minutes to see if the heat sinks on the y-sus and z-sus boards warm up, the lower one on the y-sus board remain stone cold,the post says that if any of the heats sinks dont get warm then that board has a defect, That is all i have tried so far.
If anyone can help please could you be patient with me.
Thanks
Morph
Comment