Announcement

Collapse
No announcement yet.

Phillips LCD intermittent problem no picture

Collapse
X
 
  • Filter
  • Time
  • Show
Clear All
new posts

    Phillips LCD intermittent problem no picture

    Have a Phillips LCD 47PFL7403D chassis style LC8.1ULA that is having an intermittent problem with losing picture but still has sound. Was doing it a few months ago and stopped but has since started up again. I have read some of the posts on this forum about similar problems but don't see any where the issue is completely random. Seems like it would be a short somewhere but I'm a complete newb so not sure where to start. Any info would be most appreciated.

    #2
    Re: Phillips LCD intermittent problem no picture

    Originally posted by Pants162 View Post
    Have a Phillips LCD 47PFL7403D chassis style LC8.1ULA that is having an intermittent problem with losing picture but still has sound. Was doing it a few months ago and stopped but has since started up again. I have read some of the posts on this forum about similar problems but don't see any where the issue is completely random. Seems like it would be a short somewhere but I'm a complete newb so not sure where to start. Any info would be most appreciated.
    While 'losing picture' is graphic, it doesn't really give much information.

    Does the screen go black, or dies the picture break up, go gray, or otherwise demonstrate that the backlights are working?

    If the screen goes black, can you see an image on the screen if you shine a bright light on it (it can be tricky to see this)?

    What (if anything) will cause the picture to come back?

    Note links in my signature on taking and attaching pictures.

    Service manual.

    PlainBill
    For a number of reasons, both health and personal, I will no longer be active on this board. Any PMs asking for assistance will be ignored.

    Never be afraid to try something new. Remember, amateurs built the ark. Professionals built the Titanic.

    Comment


      #3
      Re: Phillips LCD intermittent problem no picture

      The screen goes black, backlights are not working. Problem is corrected by turning it off and back on but that doesn't work every time. Sometimes when turning it back on some white light will show briefly but in splotches across the screen and then it will go black again. Other times turning it back on there are no problems. Usually doesn't start til it's been on for about 30 minutes but sometimes only 15. Doesn't happen every time but when it does, it does it a lot.

      Comment


        #4
        Re: Phillips LCD intermittent problem no picture

        That definitely sounds like inverter problems, possibly a bad transformer.

        The first step would be to take the back off and take a picture of the back of the TV. A single shot showing everything is sufficient at this time. From that I will point out specifics.

        PlainBill
        For a number of reasons, both health and personal, I will no longer be active on this board. Any PMs asking for assistance will be ignored.

        Never be afraid to try something new. Remember, amateurs built the ark. Professionals built the Titanic.

        Comment

        Working...
        X