Re: Mastervolt Chargemaster 12/35-3 Charger - Failed repair - erratic output
Thanks for the response Mr. Capleaker. I informed you that I am using the UC3845 IC in place of the UC2845 and that the ZDB8 zener that sits on the side of the UC2845 was shorted so I put a 6V8 Zener. Because the colors I saw in this zener were red, gray and blue, I interpreted DZ6V8. The load is not being triggered, nor are the LEDs lit. Thank you for your attention. Randolfo.
Thanks for the response Mr. Capleaker. I informed you that I am using the UC3845 IC in place of the UC2845 and that the ZDB8 zener that sits on the side of the UC2845 was shorted so I put a 6V8 Zener. Because the colors I saw in this zener were red, gray and blue, I interpreted DZ6V8. The load is not being triggered, nor are the LEDs lit. Thank you for your attention. Randolfo.
Comment