hello, I'm looking for HP-D3201E0 schematic, I can't see an integrated exploded features in it. Thanks for the help
-
Vizio e601i-A3 - Has Sound and Display, But No Backlight - Bad Power Supply Board or Bad LED Bulbs ?I was given this TV from my great uncle. He said it just wouldn't turn on one day out of nowhere, replaced the TV, and gave it to me to possibly fix and use for myself.
Upon bringing it home and plugging it up, it showed a standby light.
I powered it on and without a flashlight, the display showed the "V" but the lighting is very dim, but visible.
The screen seems to blackout and stay black, but with a flashlight I can see the display.
With my Playstation 4 connected via HDMI, and running a game I can hear sound.
Assuming... -
I have wanting to do this project for quite sometime now and I finally found a switching power supply that will work on this desoldering gun station ZD-915 that the original switching power supply took a shit and just was not worth trying to fix it because this switching power is not quite big enough to handle the heater element and the vacuum pump
One note when I tested the switching power supply and the voltage control board I noticed that this desoldering gun heat up much faster than the original switching power supply which I was really surprised by to the point that I might buy... -
Sick of seeing big numbers of these routers dead no power light underneath.....
Chasing Schematic of this power supply I have searched high and low....
Already spotted a few swollen caps, but Ac fuse ok.....
This is a dual output 50Vdc 2.5A and 12Vdc 1.25A psu
Can anyone help with any type of schematic and parts list ?
Thanks and Regards, Russ07-10-2025, 11:01 PM -
I have been working on this concept for quite some time now with limited success but recently I found a switching power supply that is setup for the voltage that this soldering station needs to operate at however it also needs part of the secondary circuit from the original switching power because you need several voltage rails
I once tried to get a ZD-915 desoldering station to work on a 18 volt battery power supply but unfortunately things did not go well but I did find a work around but I might try this idea again but going at a little differently more about this another time... -
Hello, I have a SYMSI70 gas heater board, which has issues with its primary side power supply, controlled by TOP247Y chip.
When I replace a TOP247Y it explode in 1 second. I have desoldered transformer and measured a winding ratio, so transformer looks like OK.
Transformer:
|Info| Primary | Aux | AB | CD|
|-|----------|----------|-|-|
|Ratio|1|25|40|12|
|Voltage AC|230V|9.2V|5.8V|19V|
|Voltage DC (*1.41)|230V|13V|8.1V|27V|
I have disabled a undervoltage protection of TOP247Y, disconnected secondaries and tried to power it up...
Comment