I am looking for schematic of ASUS X72D (17.3" notebook) Motherboard code is K72DR rev 3.0
-
Hello, i had a problem with this laptop keyboard. not working even after replacing with new original palmrest.
Solution after hours of researching is using a small software found on asus forum !
https://rog-forum.asus.com/t5/rog-ga.../701169/page/6
Thank you Bogdan CiuleiFinally some good news :I have managed to fix the problem.First,I am not responsible for any damage you might do to your hardware !YOU DO THIS AT YOUR OWN RISK ! I ONLY PROVIDE POINTERS , DO...12-09-2025, 02:27 AM -
Greetings,
So long story short, I bought an used 'previously working' Asus Maximus X Hero after the previous owner changed the RTC battery after which the board failed to display signal again, it sounded like the BIOS got somehow corrupted issue to me at first but now that I've reflashed the BIOS and poked the board a little bit more I think there's more to it.
The board is getting stuck on Q-code 00 immediately after pressing the onboard start -button. CPU and chipset are getting warm to a normal temperatures, all of the CPU's powerphases are working and nothing is visibly... -
Hi again,
The first thanks, I’ve been able to keep progressing with the tests, and as of now, I don’t think the problem is in the EC or the VBIOS.
My Bios request topic here -> https://www.badcaps.net/forum/troubl...ur#post3828581
After running MATS with the correct version for AD107, the test completes, detects the GPU correctly, and the memory bus responds, but write errors appear consistently in... -
I’m troubleshooting an ASUS ROG Strix B660-I Gaming WiFi motherboard and I’m a bit stuck at the BIOS level. What I’ve tried so far- Attempted to flash the BIOS using the USB BIOS FlashBack (Q-Flash) port with a properly formatted FAT32 USB drive.
- BIOS file downloaded directly from the official ASUS support page.
- Followed the exact FlashBack procedure (correct port, renamed file, standby power only).
Issue:
The FlashBack LED does not blink at all — no activity whatsoever. Further investigation
Because FlashBack didn’t work, I:- Removed the BIOS SPI IC from
-
Hello, I have an issue with the motherboard. Specifically, it doesn't power on, more precisely, the POST initialization doesn't occur.
Let me start from the beginning, the motherboard suddenly stopped working one day. There are no beep signals from the speaker, and the debug LEDs are not lighting up. After inspecting it under a microscope and using thermal imaging, I didn't find anything that could be damaged.
After that, I began voltage measurements, in which I noticed the absence of VDDQ, VDDP, VTT, and VPP lines. Later, I checked if there is an EN state on these lines,...
Comment