abq52 la-c811p

[pippo_one]

Hi everyone
I have a hp250 g4 with mainb la-c811p i wanted to replace my hdd with an ssd because it is too slow, but once the disk is replaced, the notebook turns on the video lights up but does not send any signal, the cursor flashes up to the left, if I press "esc / f1 / f2 / f9" at the bottom left the title of the function appears but I do not access the bios
Pls can anyone help me? is it possible that the bios is corrupt?
Thank you

[pippo_one]

Re: abq52 la-c811p

Hi , Can anyone help me ?

[piernov]

Re: abq52 la-c811p

Of course you tried putting back the original drive?

[pippo_one]

Re: abq52 la-c811p

HI, Yes I have found to put the original hdd back but nothing the problem persists

[peste]

Re: abq52 la-c811p

HI, Yes I have found to put the original hdd back but nothing the problem persists

check the HDD socket, check the contact between the HDD socket and the motherboard..if they are ok post the backup copy of the bios ..

[pippo_one]

Re: abq52 la-c811p

i checked attack hdd it looks good to me, just a question as I am a beginner, I unsoldered the cmos and now I am going with the epz2019 to read the bios, in your opinion it is better that you use a 1.8volt adapter?
thank you

[peste]

Re: abq52 la-c811p

i checked attack hdd it looks good to me, just a question as I am a beginner, I unsoldered the cmos and now I am going with the epz2019 to read the bios, in your opinion it is better that you use a 1.8volt adapter?
thank you

I don't know what bios chip you have on the motherboard and I didn't use this programmer, but, measure the voltage at pin 8 of the bios chip and use the 1.8v adapter only if you find this voltage at pin 8, to read and write the bios chip, I think the programmer should tell you if you need to use the adapter ...

[pippo_one]

Re: abq52 la-c811p

Hi, here is the backup of the bios detected
thank you

[peste]

Re: abq52 la-c811p

Hi, here is the backup of the bios detected
thank you

try..