I need help on this fix this bios 30minute shutdown attached is the original dump, can someone please fix this thanks in advance
-
Hi everyone,
I’m trying to bring a LG SK10Y soundbar back to life. Currently it is stuck in the “PLEASE WAIT” loop.
My conclusion so far is that something fails to boot fully, but it does start via eARC and can play perfectly good sound until watchdog shuts it down.
After dumping NAND with a T48 programmer, extracting with binwalk and exploring with Ghidra I think:- Kernel B is present, but no Kernel A. Is that normal?
- SquashFS A/B are present
- Bootloader is present
- UBI region is completely empty (only volume 0 / layout volume exists)
- No system.cfg,
11-13-2025, 03:19 PM -
Hi everyone,
I’m working on an ASUS B5402CEA notebook.
B5402CEA_MB_R2.2
HA4YT LA-L861P
REV:1B
The board powers on, fan spins for a few seconds, then it shuts down by itself.
I suspect the BIOS might be corrupted.
Could someone please check and clean (repair) the attached BIOS dump?
I’ve also attached a few photos of the motherboard for reference.
Thanks in advance for your help!
... -
anyone have have dell OptiPlex 3000 Tower bios
PC not turnd on all voltages ok. if i press power button a orange light just blink inside power button
MB DETAILS - D12 ENTRY Opti3/Ins/Vos/CM
OXCW8$FA
212023-1
SERVICE TAG - G6FYVQ3
I HAVE OLD DUMP ATTACHED WITH THIS POST... -
Hi all,
This is my first post here (I am very new to forums!) and I hope someone can help. I am looking for a full dump of the BIOS of a HP Proliant Microserver Gen 8 so that I can get this mini server running again. (BIOS version J06 2019-04-04, chip 25Q064A). I think my board was partially bricked after a failed BIOS update.
I got it second hand in this state and all the normal attempts at bios restoration have not worked. I have even desoldered the chip and tried to load the actual BIOS from HP, but it is missing some parts needed to boot the system.
I... -
The Samsung S49CG934SU monitor does not power on - no LED indicator activity and no response to power button. However, when 21V power is connected, it immediately draws 0.8A of current with no display output. The motherboard processor gets warm, and there is continuous reading activity from the W25Q128BV BIOS chip.
Suspected Cause:
I suspect the BIOS may have been corrupted during a power interruption while updating the firmware. The official website provides firmware updates, but they can only be installed via USB flash drive.
Troubleshooting Attempts:
...
Comment