Hi good day I really need a working bios for this board its stock only into nopress f4 no detected bootable device
-
-
Re: Need bios for BA41-0938A PTC BOARD Model XIDAN-14 Rev 1.2
are u sure its B41- 0938A and not B41-01938A ?
i think maybe you didnt type the model correctly.
so please try this and update:Last edited by ziggster; 03-05-2019, 10:32 AM. -
Re: Need bios for BA41-0938A PTC BOARD Model XIDAN-14 Rev 1.2
greatComment
-
Re: Need bios for BA41-0938A PTC BOARD Model XIDAN-14 Rev 1.2
Samsung np500p4ch xidan -14 rev 1.1 ba41-01935a ny ori testedComment
-
Hi, I have an MSI PRO B660M-G DDR4 board with damaged BIOS and i need a bios dump from a real board, along with MAC, UUID and Serial Number info (eg. a BIOS screenshot and pictures from the board stickers).
I need to reconstruct the bios on my board, based on another bios image form a real board - meaning a bios image containing MAC address, UUID and Serial number. A stock BIOS is not suffiecient, as it is impossible to discover where the MAC, UUID and SerialNumber are stored. Tried with a similar board, but there are too much differences, and the stock BIOS is missing a lot of...11-17-2023, 10:56 AM -
Hi,
If anyone can help with a BIOS for this laptop it would be greatly appreciated (I even promise a forum donation!) - basically after battery removal, I powered on and got a brief flash of a message about making a recovery BIOS USB (which I have tried multiple times, to no avail) but then just a black screen. Since attempting a BIOS recovery, I don't even now get that brief message, so whether it did actually start trying to update or not I'm not sure, but nothing appeared on screen at any point.
I've now removed the chip from the board and taken a dump file from it... -
Hi, this is my personal laptop, which the original board (lets call it Board A) blew up PU8700 (TPS51486), making a hole on the board, i had left the laptop at my desk one day with the battery fully charged and didn't touch it for a week, but when i tried to turn it on it didn't
Thought the battery was dead, so i plugged in the charger then tried to power on, the power LED blinked once, charged LED still orange, unplugged the charger, plugged in again and I noticed the "magic smoke" smell, so i unplugged the charger, removed the back cover and saw the blown IC (the "magic... -
Hi!!
Yesterday I was installing a new Wifi thermostat for my domestic gas water heater model Vaillant 242/2-3, and accidentlly one wire from mains touched one wire from the thermostat output contacts. This shut off the heater so I finished installing the thermostat and then went out to check the heater
I found one fuse blown (T2 250V). Replaced it with another equivalent fuse and it blew right away. I measured L-N in mains input and I sometimes got 4K but sometimes, not sure why, I got 100 Ohm...
At a certain point, moving stuff around, I put all wires back in place and... -
Hey guys! I've recently found out this amazing forum where people talk and discuss about electronics repairs and i'm actually amazed with everything that here's have to offer.
Oh well, i came here looking for a simple bios file in order to get my main laptop working again, but after a while trying to figure out what the hell was going on, i'm quite concerned that it would be worse than i tought. I was fooling around with Mr. Smokeless's UMAF BIOS mod, looking for a way to enable CSM compatibility and legacy boot on my device.
Device specs:
AN517-54-51RQ (LA-L181P)...
Comment