Hi, could you tell me please how did you get your usb stick prepared? Any special formating? Or just sticking in the usb stick fat32 formated with a bios files inside? Please share some of your experiance
Please i have toshiba qfkaa la- 8392p.“
1,RSMRST #” (3.3V). present
2,pwrbtn out 3.3v present
3, pch pwr en presnt. i.e u press the power btn
But s3 , s4 signals remain low and when the above signals falls low then s3, ss4 now becomes high with 3.3v.
So with this, there is no stable power and display.
the board uses 2 bios chip and still behave the same if the bios chip is off from the board
---------------------------------------------------------------------------------------------------------------------------------------------------------- All donations to Badcaps are welcome. Become a Badcaps supporter >>>>>click on this link to donate <<<<< Thanks to all supporters. ----------------------------------------------------------------------------------------------------------------------------------------------------------
Comment