the mother number is
osamu2_BT_HPC MV_MB_v1
need bios
exactly for winbond 25q64fw
osamu2_BT_HPC MV_MB_v1
need bios
exactly for winbond 25q64fw
-
-
Re: hp 15-d041TU
make a search before open a new topic.
https://www.badcaps.net/forum/showthread.php?p=628067 -
Re: hp 15-d041TU
many thanksComment
-
I have a HP 24-b010a, W2T75AA#ABG giving 2 long and 2 short beeps which means corrupted BIOS, there is a method to put the BIOS onto a USB flash drive and press either B or winkey+B or winkey+V at post to boot into BIOS recovery utility to reflash the BIOS. This isn't working because the USB ports aren't working.
I've tried flashing the BIOS chip directly it's a Winbond 25Q64FW 1.8v chip, I've tried using a raspberry pi without the power connected and turned on the AIO so it gets the 1.8v from it's own mainboard, would it be safe to try to do it with the AIO powered off and connect the... -
Hi everyone,
I hope someone can help me.
I have an Asus ROG Strix Scar 18 (G814JZ) laptop with a Winbond 25Q16JWNIG chip on the motherboard.
Unfortunately, I flashed the wrong file (BIOS/EC/other region – I'm honestly not sure anymore), and now the laptop is completely dead: no display, no fan spin, no reaction at all.
I have a CH341A programmer and I'm able to read and write to the chip. However, I'm not sure which software is best (AsProgrammer, NeoProgrammer, etc.) or if there's anything specific I should watch out for.
A valid BIOS/EC backup... -
Hello everyone,
I’m looking for a verified BIOS dump for a Beelink Gemini M mini-PC.
The device is now bricked after flashing the official BIOS file from Beelink’s website (M41N100_1018_GeminiM8G36.bin).
Details:
Model: Gemini M-H-8128QD0W64PRO
CPU: Intel Celeron J4125 (Gemini Lake Refresh)
Serial number: 4125HOLH70514
BIOS chip: Winbond 25Q128FW (8-pin SPI, 3.3 V)
Symptom: Power LED and fan run, but no HDMI output after flash.
If anyone has a working dump (.bin) for this revision,... -
Is it possible to read this cip winbond 25q256jvfq with EZP2019+ reader to remove forgotten bios password?
thanks Boris -
Hi everyone,
I’m working on a Dell PowerEdge R340 (Service Tag: JTMLKB2).
The iDRAC is bricked — system hangs at “iDRAC initializing,” fans at 100%, and no VGA output.
The cause is a bad firmware flash to the iDRAC SPI.
Board details:
- Model: Dell PowerEdge R340 (14G)
- iDRAC version: iDRAC9
- Flash chip: Winbond 25Q032 (32 Mbit / 4 MB)
- Location: iDRAC EEPROM near the BMC (ASPEED AST chip)
- Tool used: CH341A programmer
What I need:
- A clean, working 4 MB `.bin` dump of the 25Q032 from another R340...
Comment