Is it possible to read this cip winbond 25q256jvfq with EZP2019+ reader to remove forgotten bios password?
thanks Boris
thanks Boris
-
-
Due to a lack of donations, server free space at a critical level, and possible closure of Bios Requests all donations are welcome, click:
>>>>> https://www.badcaps.net/index.php?pageid=donate1 <<<<<
Every donation made will go towards server fees and maintenance costs.
-
This is a Github project, i have not used this software as i don`t own any of these programmers.The software looks good though,so i might just
have to buy one,you can never have enough programmers
QT based editor chip database for EZP2019, EZP2019+, EZP2020, EZP2023, EZP2025, MinPro programmer devices.
For linux:
https://github.com/bigbigmdm/EZP2019...ip_data_editor
Authors homepage where there`s a windows version -> https://antenna-dvb-t2.ru/EZP_programmers.php
. -
Hello how can I erase the chip 25Q128FV and write it again when I try to do that, in the end such an error comes up
i leave a picture too
Flash check error address:0h
Thanks very much... -
Hi everyone,
I hope someone can help me.
I have an Asus ROG Strix Scar 18 (G814JZ) laptop with a Winbond 25Q16JWNIG chip on the motherboard.
Unfortunately, I flashed the wrong file (BIOS/EC/other region – I'm honestly not sure anymore), and now the laptop is completely dead: no display, no fan spin, no reaction at all.
I have a CH341A programmer and I'm able to read and write to the chip. However, I'm not sure which software is best (AsProgrammer, NeoProgrammer, etc.) or if there's anything specific I should watch out for.
A valid BIOS/EC backup... -
Hello everyone,
I’m looking for a verified BIOS dump for a Beelink Gemini M mini-PC.
The device is now bricked after flashing the official BIOS file from Beelink’s website (M41N100_1018_GeminiM8G36.bin).
Details:
Model: Gemini M-H-8128QD0W64PRO
CPU: Intel Celeron J4125 (Gemini Lake Refresh)
Serial number: 4125HOLH70514
BIOS chip: Winbond 25Q128FW (8-pin SPI, 3.3 V)
Symptom: Power LED and fan run, but no HDMI output after flash.
If anyone has a working dump (.bin) for this revision,... -
Hi everyone,
I’m working on a Dell PowerEdge R340 (Service Tag: JTMLKB2).
The iDRAC is bricked — system hangs at “iDRAC initializing,” fans at 100%, and no VGA output.
The cause is a bad firmware flash to the iDRAC SPI.
Board details:
- Model: Dell PowerEdge R340 (14G)
- iDRAC version: iDRAC9
- Flash chip: Winbond 25Q032 (32 Mbit / 4 MB)
- Location: iDRAC EEPROM near the BMC (ASPEED AST chip)
- Tool used: CH341A programmer
What I need:
- A clean, working 4 MB `.bin` dump of the 25Q032 from another R340...
Comment