Re: Samsung NP300E5C bios dump needed
Hello, I need BIOS for this model:
Marca -samsung
Modelo -NP300E5E
Thanks!!!
Hello, I need BIOS for this model:
Marca -samsung
Modelo -NP300E5E
Thanks!!!
-
Saludos, Villa -
-
Re: Samsung NP300E5C bios dump needed
thank you for sharingComment
-
Re: Samsung NP300E5C bios dump needed
Thanks for the bios!Comment
-
Re: Samsung NP300E5C bios dump needed
theanksComment
-
Re: NP300e5c Killing input FET after some time.
I just had this particular notebook here for repair, finally fixed (For everyone else having the same- or similar fault).
In my case it was a BIOS issue (or more likely EC FW, that comes with the update).
Symptoms were, that the notebook only ran on batty, gate voltage was too low on input MOSFETs.
so what I did:- Bridge gate to enable input MOSFETs and charge the battery
- Update BIOS to latest version (attached, original from Samsung Update)
- Remove bridge
suddenly, gate voltage is correct and notebook runs on AC and Battery again.
Hope I could help. Cheers!Comment
-
sasmsung np300e5c p04rap
can someone fix this bios please no display problem at fan at full speedComment
-
Due to a lack of donations, server free space at a critical level, and possible closure of Bios Requests all donations are welcome, click:
>>>>> https://www.badcaps.net/index.php?pageid=donate1 <<<<<
Every donation made will go towards server fees and maintenance costs.Comment
-
Re: sasmsung np300e5c p04rap
thanks but still no displayComment
-
Re: sasmsung np300e5c p04rap
Try this one,updated to P09 from the extracted updater at post #50 ,+ your DMI + clean ME .The platform ID is RAP https://www.badcaps.net/forum/showthread.php?t=88206
.Last edited by SMDFlea; 02-28-2022, 06:29 AM.Comment
-
Re: Samsung NP300E5C bios dump needed
It works, Thank you so much!Comment
-
Re: Samsung NP300E5C bios dump needed
Thanks for the bios bin file.
Comment
-
thxxxππComment
-
Greetings all, could you please assist with the unlocking of this BIN
Samsung NP300E5C
Board Number: BA41-01979A
I've tried many files and it didn't work.
Please find attached the BIN
Comment
but i disabled secure boot because its not booting from my drive. maybe its about my instalation 
-
The Samsung S49CG934SU monitor does not power on - no LED indicator activity and no response to power button. However, when 21V power is connected, it immediately draws 0.8A of current with no display output. The motherboard processor gets warm, and there is continuous reading activity from the W25Q128BV BIOS chip.
Suspected Cause:
I suspect the BIOS may have been corrupted during a power interruption while updating the firmware. The official website provides firmware updates, but they can only be installed via USB flash drive.
Troubleshooting Attempts:
... -
Hi all,
My Samsung Galaxy Book 2 Pro 15.6-inch laptop has no display and won't boot.
The charging red LED lights up, but the charging screen doesn't show any indication.
When I press the power button, the blue LED cycles on and off three times, then the screen doesn't turn on, and the device won't boot.
(I've tried removing the battery and resetting the device, but the issue persists.)
NoteBook Model name : Samsung NT955XED-KK51G(Galaxy book2 pro, i5-1240p, 15.6inch AMOLED)
PCB model name : Venus2-15-5G(REV1.2), Venus2-15 ADL NPC
S/N : 5RNK9FFT70... -
Hi, I have an MSI PRO B660M-G DDR4 board with damaged BIOS and i need a bios dump from a real board, along with MAC, UUID and Serial Number info (eg. a BIOS screenshot and pictures from the board stickers).
I need to reconstruct the bios on my board, based on another bios image form a real board - meaning a bios image containing MAC address, UUID and Serial number. A stock BIOS is not suffiecient, as it is impossible to discover where the MAC, UUID and SerialNumber are stored. Tried with a similar board, but there are too much differences, and the stock BIOS is missing a lot of...11-17-2023, 10:56 AM -
Hi everyone,
I'm trying to recover a Fujitsu Lifebook E5513 (most likely 2023 model) that was bricked during a BIOS update. The update was interrupted (probably due to power loss), and now the laptop is stuck in a boot loop showing "PBB rollback" / "SBB rollback" messages.
BIOS access (F2) and Boot Menu (F12) are no longer possible β the system instantly reboots after the rollback messages.
I extracted the official BIOS update package from Fujitsu (contains FJNB2FD.CAP, ~18.7 MB) and tried tools like UEFIExtract, but it seems to only contain... -
After installing Linux, I can no longer enter the BIOS of my Samsung Series 9 (NP900X3C) laptop. When pressing [F2] during boot I simply get a black screen. Same thing when pressing [F10] and choosing "Setup" from the "App Menu" tab. Apparently this is a relatively common issue with Samsung laptops of that generation, but unfortunately i haven't been able to resolve the issue (yet).
Things i've tried so far; reinstalled Windows 10, checked for redundant boot entries, tried to factory reset using the emergency keyhole, attempted to clear the NVRAM by physically...08-01-2025, 09:15 AM
Comment