Hey everyone,
Working on an iPhone 5, came in for data recovery.
Phone booted straight into recovery mode, connected it to 3uTools, used "exit recovery mode", and since then it just bootloops. I get the Apple logo, after a good 5 to 10 seconds, then power gets cut and the logo fades.
Took it out of the housing, only battery, chargeport and screen connected, same issue. took off the heatshield to measure a bit, but I'm not experienced with iPhone 5 so no clue what to check first.
With a thermal cam I could see L2 heats up to about 45c, and sometimes the U7 chip next to get get a little heatspot close to it. Connected to a power supply it never draws more then 0.29a.
Where do I go from here? What should I measure? Thanx in advance!
Working on an iPhone 5, came in for data recovery.
Phone booted straight into recovery mode, connected it to 3uTools, used "exit recovery mode", and since then it just bootloops. I get the Apple logo, after a good 5 to 10 seconds, then power gets cut and the logo fades.
Took it out of the housing, only battery, chargeport and screen connected, same issue. took off the heatshield to measure a bit, but I'm not experienced with iPhone 5 so no clue what to check first.
With a thermal cam I could see L2 heats up to about 45c, and sometimes the U7 chip next to get get a little heatspot close to it. Connected to a power supply it never draws more then 0.29a.
Where do I go from here? What should I measure? Thanx in advance!
The boardnumber of the schematic I'm working of is 820-3141-B.
Comment