Learnign question about capacitors

Collapse
X
Collapse
 
  • Page of 1
  • Time
  • Show
Clear All
new posts
Previous template Next
  • koby058
    Badcaps Veteran
    • Jan 2017
    • 365
    • israel
    #1

    Learnign question about capacitors

    Hi,

    Often you find your self fixing a laptop mobo with no schematics.

    Often it is a shorted cap that is causing the issue but since no schematic one do not know the cap's values.

    The question is: is there like a high value cap that can cover multiple scenarios or a way to found out a cap value?

    Thanks from advanced
    Tags: None
    • BalkanBoy
      Senior Member
      • Feb 2017
      • 69
      • Croatia
      #2
      Re: Learnign question about capacitors

      From my experience, every time cap gets shroted it's one of few that are connected in parallel, I never had problem where isolated cap died. So when you find the shorted one you remove other next to it, measure it and find the same one to replace. I even practice replacing all of those caps next to shorted one, if I have time ofc.

        Comment

        • koby058
          Badcaps Veteran
          • Jan 2017
          • 365
          • israel
          #3
          Re: Learnign question about capacitors

          Thanks, sounds like a good idea

            Comment

            Previous template Next

            Related Topics

            Collapse
            • dragon3x
              After updating motherboard capacitors, what to do next (Asrock K7VT2, SOLTEK SL-75FRN2L)
              by dragon3x
              Hi, I have some 32 bits computer motherboards that need repair, as they fail to
              power on.

              Here are some examples :

              (N.B. "capacitors" indicated here are electrolytic capacitors located in the onboard
              switching supply area).
              (N.B. #2 : I could not find a 3300 microF aluminum-polymer with a higher voltage
              than 6.3 V.)

              1 - Motherboard #1 : this is an Asrock K7VT2 (socket A) that still works well. To put it on test
              I replaced capacitors with aluminum-polymer.
              3300 microF/6.3 V. x 4 replaced by 3300 microF/6.3 V. (KYOCERA...
              03-21-2025, 02:46 PM
            • slybunda
              AA and AAA battery charger capacitors?
              by slybunda
              hey all, iv got my favourite battery charger here which iv had for many years probably 15 years now or maybe even more. it still works good but thought id open it up to clean the dust out of it, lots of dust inside but now its clean and noticed 4 capacitors inside it and wondered if i should replace them.
              it has inside:
              2 x 47uf 16v caps 105c branded as Su'scon (lol sounds sus to me)
              2 x 470uf 16v LZ105c branded as G.Luxon

              not heard of these brands are they any good?

              iv attached photos of the charger and the board inside for an idea on the type of...
              12-24-2023, 04:41 AM
            • sam_sam_sam
              Panasonic switching power supply daughter board has two 27uf @ 50 volt capacitors which I do not keep in stock
              by sam_sam_sam
              I did not have any 27uf @ 50 volt capacitors but one nice thing is that it has enough room for two capacitors in parallel a 22uf and a 4.7uf @ 50 volts 22 plus 4.7 equals 26.7uf which so very close to 27uf I will show some pictures of it sometime tomorrow

              This is one of the shit est boards I seen in a very long time and it was the daughter board the traces just lifting off the board I had to use the capacitor leads to repair the the traces and the main board is not any better because I had to repair several traces for the daughter board to the main board

              After all of...
              07-13-2024, 08:14 PM
            • Ady2017
              Are there any datasheets available for Elna RJG capacitors?
              by Ady2017
              I have a 2007-era Panasonic VHS combo that is full of of Elna RJG capacitors. I am trying to test the capacitors to diagnose the machine and then select replacement capacitors but I can not find any datasheets for them. I did find a Elna catalogue from 2007-2008 but there is no mention of this capacitor series. Where these specially made for Panasonic and so not made available to the public? Any ideas what to find out what the ESR values should be without the datasheets? They are all between 10V and 50V and 47uF and 1800uF. None are leaking or bulged but I know that they need to be tested to be...
              05-25-2025, 02:19 PM
            • ctroxtell
              Samsung UN70tu7000wxza no standby light, do I have bad capacitors?
              by ctroxtell
              I picked up a 70" Samsung UN70TU7000WXZA. The original owner said they were watching it when the power surged and knocked it out. I pulled the back off the TV and disconnected the main board from the power board, and the LED backlight came on, which I was told meant the power board was good. When everything is plugged in the standby light will not come on, looking at the main board BN94-17775A with a thermal imaging gun I can see one of the chips labeled 3202 is 251 degrees F just sitting idle. I found a replacement board, BN94-16115X; this board has the same symptoms, except it is a different...
              01-03-2025, 08:57 PM
            • Loading...
            • No more items.
            Working...