Re: Asus X555LD Rev. 3.1 no power
PU 9100 was soldered today. Problem persists, I think +3VA_EC is on short.
Shall I put 3v on this rail and watch which component gets warm?
Resistance to grund of 3VA_EC is only 1,5 ohms.
/edit: Or shall I desolder the KBC / SIO chip and see if +3VA_EC is present then?
PU 9100 was soldered today. Problem persists, I think +3VA_EC is on short.
Shall I put 3v on this rail and watch which component gets warm?
Resistance to grund of 3VA_EC is only 1,5 ohms.
/edit: Or shall I desolder the KBC / SIO chip and see if +3VA_EC is present then?
Comment