S IC NPCE288NB0DX LQFP 128P KBC
nuvoton ic do i need same controller or will winbound work ?
nuvoton ic do i need same controller or will winbound work ?
-
Last edited by Stevie2001; 07-10-2018, 08:44 AM. -
Re: a
Nuvoton is there alternative to this.
Can i use winbound -
Re: a
No, there is no alternative. You need NPCE288xxx only. This IC is programmable-so keep that in mind.Comment
-
Re: a
The kbc may be short but unlikely to pull 19v rail to 7v,coz 19v rail doesnt touches kbc at all. You can remove the kbc and then put power on mb and see if 19v rail beomes stable.Comment
-
Hello friends.
searching nuvoton nct 6683d schematic.
for lenovo la-c671p....10-16-2025, 02:43 AM -
EVGA 360AIO with LCD. Aio and lcd not work. Cannot find NUC1261NE4AE Nuvoton that have burn mark on it.
Anyone knows where to find it?08-02-2025, 06:40 AM -
Hi, Recently my Samsung 4K QE55Q60AAUXXH just suddenly stopped working_ there is no any sign of life - no red light or anything..and think, after diagnostic, it is diode DM863c SF28e PK33 siyu or one of these four. Is there any alternative I can replace with since it is hard to find it in my country and to order outside is quite difficult. thank you... -
before you start the procedure read the bios eeprom and save it you might need it at the end
1do not power on your svod yet
2plug you ribbon 30x0.5 to the left of the keyboard connector
3test pin with testeur if it beep go to next stage
4 open svod software select 1.8v
5 now plug your svod
6 select nuvoton
7 plug charger on the board/laptop
8 press read id
9 select 256k
10 read nuvoton
11 save reading, now unplug the svod
12 open HxD software and open your 256k file the one you just saved
13look... -
Hi,
A friend of mine gave me an iPod nano G3 to see if I can fix it for him.
The device had a faulty battery and he tried to replace it but failed. In the process he managed to pull off the pads that corresponds to the white battery wire (marked with a red circle in the images)....from both sides of the PCB. Fortunetely he didn't damage anything else.
This is usually an easy fix HOWEVER, on the PCB, I see no traces coming from the VIA and after searching the internet, I've found no schematics nor boardview for this device. With the pads gone from both sides I seem...
Comment