Hello guys. What programmer can I use to program the EC IT8886HE? I have the TL-866II PLUS but it is not in the library, nor is any of the ITE family.
-
Hi everyone, does anyone use this programmer "T48 TL866II Plus High speed Universal Programmer"?
I am planning to buy a programmer for my Dell Precision 7710 to re-flash the bios.... -
Greetings badcaps community,
I havent done this for a long time and want to start it all again, after some evil and annyoing illness.
So I apologize in advance, if some phrases might sound a bit like gibberish or illogical to you.
Im trying my best to fully describe what I plan to achieve and hope I was choosing the right sub-forum for my new adventure.
I have a Elitebook 820 G1 and a Elitebook 840 G2 here.
These ask for a password when entering the BIOS, but boot just fine from the internal SSD.
I learned that desoldering...10-29-2024, 06:03 AM -
Well, I see that I last posted on the subject of BIOS programmers Many years ago now. At that time I bought a Willem Programmer 5.0 which has the Parallel port and USB connectors. I never figured out how this was intended to work whether it was powered from the USB, the Parallel port on the card, or both. I never found a printer cable to make it work so that was a waste of $50.
There is now the TL866II programmer which has only the USB connectivity. Phil's Computer Lab on YouTube has a demonstration of the use of this new programmer.
Has anyone used on of these newer... -
Hellow guys , i really need your help here.
Lately i have a problem with My TL 866 II Plus programmer, and to be more specific many times on various IC ( Winbond, Gigadevice Mx) i get Check ID Error while i am trying to read the IC. Has already been detected without any kind of problem, but the only to read them is to uncheck every time the "Check ID " option. After that i can read it erase it and re-program it only to get another error at then end saying that can not verify the programing went well so i have program failed. So i am trying to find out what is going on? I... -
I am trying to program the EC IT8886HE of a Lenovo V310-15ISK with RT809H. (Motherboard DA0LV6MB6F0 REV: E)
According to the programmer's software, it must be connected to the SM BUS of the EC (pins 87 and 88 if I'm not mistaken) through the ISP port of the programmer. However, when I want to read or delete the EC it tells me "bot error"
Someone has programmed these ECs to help me or tell me what mistake I am making. I leave the photos of the connection diagram, the error that appears and the photo of how I connected the ISP cables
Thank you so...
Comment