LA-D801P SUPER SLOW
the unit came dead and after removing battery and put the charger the laptop works but no image.. try to repair me region/bios region and the laptop works but 2nd problem the laptop is so slow I even put brand new ssd .. does someone know how to solve this problem?
-
-
The bios may be the fault of the super slow speed. -
okay i will try it again to replace the me region in WIN RAID site i will keep u updatedComment
-
use original dell charger check in the bios if the motherboard communicate with the chargerComment
-
Dell throttle when power supply is not recognized in bios.Comment
-
Title:
Capacitor detached from PCB – RTX 2070 Super Founders Edition
Description:
During maintenance on an RTX 2070 SUPER Founders Edition, I found a capacitor lying on my desk after reassembly.
I did not notice it detaching, so I am unsure of its original location on the PCB.
Procedure performed:
- Removed backplate
- Cleaned heatsink and PCB with isopropyl alcohol + soft ESD brush
- Reapplied thermal compound
- Reassembled card
Observed behavior after reassembly:
- GPU powers on and operates normally under... -
[HELP] Acer AN515-55 (LA-J871P Rev: 1B) – Board won't power on after GPU investigation – Suspecting Super I/O or PCH
Hi everyone,
I'm working on an Acer Nitro 5 unit with the following specs:- Motherboard: LA-J871P Rev: 1B
- Model: Acer AN515-55-59MT
- S/N: NHQ7JAL00403906A973400
- SNID: 03902728734
Initial Issue
The laptop initially presented graphic issues and driver failure (Code 43) for the GPU.
After preventive maintenance (cleaning, thermal paste, etc.), it powered on normally. We disassembled it again to inspect the GPU, reassembled... -
Hi All,
I recently got a bunch of faulty/partially faulty PS3s and wanted to get some advise on them. Models are:
X4 are PS3 slims with disc drive errors.
X1 is a PS3 slim with the 8002F1F9 update error.
X1 is a ps3 slim with no display.
X1 is a slim with RLOD
X1 is a super slim with a missing disc drive and receiving the same update error 8002F1F9 (I'm assuming because it needs it's drive)?
X1 is another super slim with no power (board number MPX-001).
Does anyone know of any good resources that list parts interchangeability?... -
Hello everyone, I received a PS3 console with the issue described in the title. I gradually measured the console (both the PSU and the motherboard) but couldn’t find anything—everything seems fine.
I planned to remove the casing and test whether the voltages appear on the coils, but after rewiring and turning the console on without the casing, the system actually booted, which blew my mind (it’s been seven days that I’ve been dealing with this). The processor started heating up, so I quickly turned the console off and tried reinstalling the heatsinks and turning it on again....11-22-2025, 01:47 PM -
I’m working on a laptop in which I replaced the PCH, but I’m unable to clean or rebuild the Intel ME region using FIT.
When I load my dump into FIT, it only shows the Intel(R) ME Kernel section. The full ME region structure does not appear.
If I manually replace the ME region inside the decomp folder and try to build the image, FIT does generate an outimage.bin, but the file is corrupted.
After flashing it, the board does not power on — no signs of life.
I’ve identified that the issue happens because my original dump does not contain a complete or valid ME...
Comment