Fx506hc-da0njjmbag0 rev:g
I need this integrated. whats this piece?
thank you guys.
thank you guys.
Attached Files
-
-
Re: Fx506hc-da0njjmbag0 rev:g
Getting close..
It is PU31 in the boardview file here (last post):
https://www.badcaps.net/forum/showth...00#post1132300
Symbol on part = AOSMD is the manufacturer.
Schematic has a different device at PU31. -
Comment
-
Re: Fx506hc-da0njjmbag0 rev:g
I believe it is very close to the attached. Still confirming.Comment
-
.Working on a new list to add to the AO IC marking codes post-
Hello, I search this connector (oxydated).
It's a fpc zif low profile connector. It come from camera sensor, it is very small : 0.3mm between 2 pins.
I ordered 2 from Aliexpress called « 0.3mm pitch » but one was 0.5mm between 2 pins and the other 0.6mm. In fact « 0.3mm pitch » seams to be the pad width and not the distance between 2 pins.
I can't find it. The other websites like mouser dont show the datasheet, and I can't check if it is 0.3mm between 2 pins ?
Do you know how to find this connector please ? What is the exact name for find it ?
... -
vizio e650i-a2 (LWJAOZBP Serial) led backlight flashes then turns off, has video (via flashlight) and audio.
panel: au optronics T650HVN05.4
72 led total on 12 strips, 6 led per strip wired in three groups of 24 (led driver board has three anode and three cathode pins)
link to datasheet: https://datasheetspdf.com/pdf-file/8.../T650HVN05.4/1
Vizio 56.04219.641G (liteon PA-3231-01WN-LF) Power Supply Unit
https://www.shopjimmy.com/vizio-56-0...-power-supply/
Vizio 55.75J01.001G (91.75J10.004G) Main Board... -
Hello,
I am a new forum member. I found a broken MSI motherboard with lot of problems. The other problems need schematic. Because, the missing parts what were breaking down with screwdriver and pliers at a standoff.
So, its actual problem is a missing Vcore and Gnd pins in the CPU socket. My question is that, can it be used safely without these two pins? Only for testing at first, while the other problems will be solved. I would wish repair them later.
The other spots are thermal phaste, because, the under educated installer of the CPU did wipe the contacts of the... -
Does anyone know what pins i need to short to power on the Dell XPS 13 9315 clamshell? I have just the main board and I would like to get into the BIOS to enable boot on AC. Can anyone help me?07-27-2025, 10:23 PM -
Hi everyone,
Can someone help me with a schematic/boardview of this phone?
I'm looking to identify the rx and tx uart pins on the board.
Because I want to use the usb-port for power and other things, I can not use the uart over usb method.
I took some pictures but without the boardview/schematic it's a bit daunting.
Images:
https://photos.app.goo.gl/vzYVtVcZgz8trCT48
I'm uspecting the masked pads above the ufs chip. (but offcourse I'm not sure).07-21-2025, 08:49 AM
Comment